# 2025-13714: FAA Proposes More Frequent Crack Checks for Boeing 737s

2025-13714, Airworthiness Directives; The Boeing Company Airplanes, is a Federal Register proposed rule from Transportation Department, Federal Aviation Administration published 2025-07-22, effective The FAA must receive comments on this proposed AD by September 5, 2025.; PRIA reads it as touching household money (as of 2026-11-16).

- Canonical: https://policyrisk.com/federal-register/2025-13714
- As of: 2026-11-16
- Plain-text twin of the page above; the HTML and this file carry the same facts.

## Facts
- Document number: 2025-13714
- Title: Airworthiness Directives; The Boeing Company Airplanes
- Type: Proposed Rule
- Agencies: Transportation Department; Federal Aviation Administration
- Citation: 90 FR 34388
- Published: 2025-07-22
- Effective: The FAA must receive comments on this proposed AD by September 5, 2025.
- Comments close: not stated
- Significant: no
- Touches household money: yes
- Regulation identifier numbers: 2120-AA64
- Last updated: 2026-11-16

## In one line

FAA Proposes More Frequent Crack Checks for Boeing 737s

## Summary

If you own or operate Boeing 737-800 airplanes, the FAA wants you to speed up inspections for cracks on the plane’s skin to keep flights safe. They’re updating rules to check more often and add extra inspections after certain fixes. Comments on these changes are open until September 5, 2025, so get ready to act and keep those planes flying strong!

## Abstract

The FAA proposes to supersede Airworthiness Directive (AD) 2013-08-15, which applies to certain The Boeing Company Model 737-800 series airplanes. AD 2013-08-15 requires repetitive inspections for cracking of the fuselage skin along chem-mill steps at certain crown skin and shear wrinkle areas and repair if necessary. Since the FAA issued AD 2013-08-15, the FAA has determined that the compliance times are not adequate. This proposed AD would continue to require the actions in AD 2013-08-15 but at reduced compliance times and would require post-modification inspections if an optional terminating action is accomplished. The FAA is proposing this AD to address the unsafe condition on these products.

## Effects PRIA read

- Faster inspections required for 737-800 skin: cost, high. If you operate Boeing 737-800 airplanes, the FAA proposes shorter (reduced) inspection thresholds and more frequent inspections for fuselage skin cracking where chem-mill steps and shear wrinkles occur. The prior AD required initial inspections before 43,000 total flight cycles; this proposed AD wo…
- Optional modification: big upfront cost, inspection relief: mixed, high. Operators may choose an optional modification (installing doublers) that ends repetitive inspections for the modified area, but only after pre-mod inspections and a high-frequency eddy-current inspection of holes. Boeing’s service bulletin and the FAA estimate the modification labor at 808 work-hou…
- Repairs required before further flight if cracks found: cost, medium. If any inspection required by this AD finds cracking, the airplane must be repaired before further flight using an FAA-approved repair method. That requirement can ground an airplane until the repair is completed.
- Applies to 528 U.S.-registered 737-800 airplanes: cost, low. The FAA estimates this proposed AD would affect 528 airplanes of U.S. registry that are Boeing Model 737-800 series, as identified in Boeing Special Attention Service Bulletin 737-53-1311, Revision 1, dated May 22, 2024. Comments on the proposed rule are due by September 5, 2025.
- STC ST00830SE does not change compliance needs: benefit, low. If your airplane has Supplemental Type Certificate (STC) ST00830SE installed, that STC does not affect the ability to accomplish the AD’s required actions, and operators with that STC do not need a ‘‘change in product’’ alternative method of compliance (AMOC) to comply with 14 CFR 39.17.

## Related documents

- [2026-15585](https://policyrisk.com/federal-register/2026-15585): Requirements for Interference-Tolerant Radio Altimeter Systems, 2026-07-31
- [2026-13440](https://policyrisk.com/federal-register/2026-13440): Enabling Supersonic Overland Flight, 2026-07-02
- [2026-13126](https://policyrisk.com/federal-register/2026-13126): Designation-Restrict the Operation of Unmanned Aircraft in Close Proximity to a Fixed Site Facility; Extension of Comment Period, 2026-06-30
- [2026-08943](https://policyrisk.com/federal-register/2026-08943): Designation-Restrict the Operation of Unmanned Aircraft in Close Proximity to a Fixed Site Facility, 2026-05-06
- [2025-04846](https://policyrisk.com/federal-register/2025-04846): Extension of the Prohibition Against Certain Flights in the Territory and Airspace of Libya, 2025-03-20
- [2025-03853](https://policyrisk.com/federal-register/2025-03853): Enforcement Policy Regarding “Drug and Alcohol Testing of Certificated Repair Station Employees Located Outside of the United States; Corre…, 2025-03-11

## Sources
- [2025-13714 on federalregister.gov](https://www.federalregister.gov/documents/2025/07/22/2025-13714/airworthiness-directives-the-boeing-company-airplanes)
- [2025-13714 as published (PDF)](https://www.govinfo.gov/content/pkg/FR-2025-07-22/pdf/2025-13714.pdf)

## Related
- [Previous: 2025-13697, Hazardous and Solid Waste Management System: Disposal of Coal Combustion Residu…](https://policyrisk.com/federal-register/2025-13697)
- [Next: 2025-13742, Airworthiness Directives; Schempp-Hirth Flugzeugbau GmbH Gliders](https://policyrisk.com/federal-register/2025-13742)
- [All Federal Register documents](https://policyrisk.com/federal-register)

Source: PRIA, https://policyrisk.com/federal-register/2025-13714 (as of 2026-11-16).
