# 2026-03782: FAA to Boeing Pilots: Peek at Those Landing Gear Cracks Regularly

2026-03782, Airworthiness Directives; The Boeing Company Airplanes, is a Federal Register proposed rule from Transportation Department, Federal Aviation Administration published 2026-02-25, effective The FAA must receive comments on this proposed AD by April 13, 2026. (as of 2026-06-11).

- Canonical: https://policyrisk.com/federal-register/2026-03782
- As of: 2026-06-11
- Plain-text twin of the page above; the HTML and this file carry the same facts.

## Facts
- Document number: 2026-03782
- Title: Airworthiness Directives; The Boeing Company Airplanes
- Type: Proposed Rule
- Agencies: Transportation Department; Federal Aviation Administration
- Citation: 91 FR 9205
- Published: 2026-02-25
- Effective: The FAA must receive comments on this proposed AD by April 13, 2026.
- Comments close: not stated
- Significant: no
- Touches household money: no
- Regulation identifier numbers: 2120-AA64
- Last updated: 2026-06-11

## In one line

FAA to Boeing Pilots: Peek at Those Landing Gear Cracks Regularly

## Summary

The FAA wants Boeing 777 pilots and maintenance crews to regularly check certain landing gear parts for cracks and damage to keep flights safe. These inspections will happen over and over, and if problems pop up, fixes must be done right away. Comments on this plan are open until April 13, 2026, and while it might cost some time and money, it’s all about keeping planes flying safely.

## Abstract

The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 777-200, -200LR, -300, -300ER, and 777F series airplanes. This proposed AD was prompted by reports of cracks found on the main landing gear (MLG) support beam lower stabilizer brace aft fitting lower flange attachment holes. This proposed AD would require repetitive inspections of the MLG support beam lower stabilizer brace aft fittings for any crack; repetitive inspections of the MLG support beams and lower stabilizer braces for any damage; repetitive inspections of the MLG support beams and the upper and lower flanges of the MLG support beam lower stabilizer brace aft fittings for any crack, or repetitive inspections of the upper and lower flange surfaces of the MLG support beam lower stabilizer brace aft fittings for any crack; and applicable on-condition corrective actions. The FAA is proposing this AD to address the unsafe condition on these products.

## Effects PRIA read

- Mandatory 777 landing-gear inspections: cost, medium. If you operate or maintain Boeing 777-200, -200LR, -300, -300ER, or 777F airplanes, the FAA would require repetitive inspections of the main landing gear (MLG) support beam lower stabilizer brace aft fittings and related parts per Boeing Alert Requirements Bulletin 777-57A0128 RB, dated June 2, 202…
- Estimated inspection cost per airplane and fleet: cost, high. The FAA estimates each repetitive inspection cycle takes 35 work-hours at $85 per hour, costing $2,975 per airplane per inspection cycle. The agency estimates the rule would affect 311 U.S.-registered airplanes, for a total estimated cost of $925,225 per inspection cycle across the U.S. fleet.
- Possible replacement expense for cracked parts: cost, high. If inspections find a cracked MLG support beam lower stabilizer brace aft fitting, operators must replace it and follow post-replacement inspections. The FAA estimates replacement requires 41 work-hours at $85 per hour and identifies parts cost of $17,065 for that replacement.
- Inspections reduce severe landing-gear failure risk: benefit, high. The FAA says cracks in the MLG support beam lower stabilizer brace aft fitting could lead to the main landing gear collapsing, potential fuel-tank breach, and possible fire or explosion. Repetitive inspections and repairs aim to reduce the risk of MLG collapse during takeoff, landing, or ground ope…

## Related documents

- [2026-15585](https://policyrisk.com/federal-register/2026-15585): Requirements for Interference-Tolerant Radio Altimeter Systems, 2026-07-31
- [2026-13440](https://policyrisk.com/federal-register/2026-13440): Enabling Supersonic Overland Flight, 2026-07-02
- [2026-13126](https://policyrisk.com/federal-register/2026-13126): Designation-Restrict the Operation of Unmanned Aircraft in Close Proximity to a Fixed Site Facility; Extension of Comment Period, 2026-06-30
- [2026-08943](https://policyrisk.com/federal-register/2026-08943): Designation-Restrict the Operation of Unmanned Aircraft in Close Proximity to a Fixed Site Facility, 2026-05-06
- [2025-04846](https://policyrisk.com/federal-register/2025-04846): Extension of the Prohibition Against Certain Flights in the Territory and Airspace of Libya, 2025-03-20
- [2025-03853](https://policyrisk.com/federal-register/2025-03853): Enforcement Policy Regarding “Drug and Alcohol Testing of Certificated Repair Station Employees Located Outside of the United States; Corre…, 2025-03-11

## Sources
- [2026-03782 on federalregister.gov](https://www.federalregister.gov/documents/2026/02/25/2026-03782/airworthiness-directives-the-boeing-company-airplanes)
- [2026-03782 as published (PDF)](https://www.govinfo.gov/content/pkg/FR-2026-02-25/pdf/2026-03782.pdf)

## Related
- [Previous: 2026-03758, Statutory Liens](https://policyrisk.com/federal-register/2026-03758)
- [Next: 2026-03783, Airworthiness Directives; Embraer S.A. (Type Certificate Previously Held by Yab…](https://policyrisk.com/federal-register/2026-03783)
- [All Federal Register documents](https://policyrisk.com/federal-register)

Source: PRIA, https://policyrisk.com/federal-register/2026-03782 (as of 2026-06-11).
