# 2026-08106: FAA Mandates Checks on Pratt & Whitney Engines for Safety

2026-08106, Airworthiness Directives; Pratt & Whitney Engines, is a Federal Register rule from Transportation Department, Federal Aviation Administration published 2026-04-24, effective 2026-05-29; PRIA reads it as touching household money (as of 2026-06-11).

- Canonical: https://policyrisk.com/federal-register/2026-08106
- As of: 2026-06-11
- Plain-text twin of the page above; the HTML and this file carry the same facts.

## Facts
- Document number: 2026-08106
- Title: Airworthiness Directives; Pratt & Whitney Engines
- Type: Rule
- Agencies: Transportation Department; Federal Aviation Administration
- Citation: 91 FR 21945
- Published: 2026-04-24
- Effective: 2026-05-29
- Comments close: not stated
- Significant: no
- Touches household money: yes
- Regulation identifier numbers: 2120-AA64
- Last updated: 2026-06-11

## In one line

FAA Mandates Checks on Pratt & Whitney Engines for Safety

## Summary

The FAA is rolling out new safety checks for certain Pratt & Whitney engines to catch cracks early and keep flights safe. Starting May 29, 2026, operators must perform regular ultrasonic inspections and replace parts if needed, preventing engine shutdowns like a recent scary incident. This means some extra work and costs but keeps everyone flying worry-free!

## Abstract

The FAA is adopting a new airworthiness directive (AD) for certain Pratt & Whitney (PW) Model F117-PW-100, PW2037, PW2037D, PW2037M, PW2040, and PW2040D engines. This AD was prompted by an updated analysis of an event involving an International Aero Engines, LLC (IAE LLC) Model PW1127GA-JM engine, which experienced a high- pressure compressor (HPC) 7th-stage integrally bladed rotor (IBR-7) separation that resulted in an engine shutdown and aborted takeoff. This AD requires repetitive angled ultrasonic inspections (AUSIs) of certain high-pressure turbine (HPT) 1st-stage disks and turbine hubs for any crack indications, and if necessary, removal from service and replacement, and removal from service of certain HPT lenticular seal assemblies. The FAA is issuing this AD to address the unsafe condition on these products.

## Effects PRIA read

- Mandatory angled ultrasonic inspections: cost, low. Starting May 29, 2026, operators of the affected Pratt & Whitney engines must do angled ultrasonic inspections (AUSIs) of the high-pressure turbine (HPT) 1st-stage disk and the turbine hub at the next piece-part exposure and at every piece-part exposure thereafter. Each AUSI is estimated at 5 work-…
- Required removal and replacement for crack findings: cost, high. If any crack indication is found during the required AUSIs, the affected part must be removed from service and replaced with a part eligible for installation. The FAA lists on-condition replacement costs of $730,850 for an HPT 1st-stage disk and $500,850 for a turbine hub (10 work-hours labor + par…
- Mandatory removal of specific seal assemblies: cost, high. For engines with HPT lenticular seal assemblies having P/N 1B8575 and the serial numbers listed in figure 1 of the AD, operators must remove those assemblies from service at the next piece-part exposure. For serial number DKLBG48292, removal is required at the next piece-part exposure or before exc…
- Installation prohibitions for certain parts: cost, low. As of May 29, 2026, no person may install HPT 1st-stage disks with P/N 1B7801, 1B3601, or 1B3601-001, or turbine hubs with P/N 1B4902, 1B6602, or 1B8002, unless the part is a 'part eligible for installation' as defined in the AD (for example, having passed the required AUSI, having NDIP conformance…
- Update ALS as optional terminating action: benefit, medium. Operators may optionally revise the airworthiness limitations section (ALS) of the engine manual and their approved maintenance/inspection program by adding the inspections in figure 2 of the AD (ALS revision date entries show Revision Date: 2025-02-01). Doing this revision constitutes terminating…

## Related documents

- [2026-15585](https://policyrisk.com/federal-register/2026-15585): Requirements for Interference-Tolerant Radio Altimeter Systems, 2026-07-31
- [2026-13440](https://policyrisk.com/federal-register/2026-13440): Enabling Supersonic Overland Flight, 2026-07-02
- [2026-13126](https://policyrisk.com/federal-register/2026-13126): Designation-Restrict the Operation of Unmanned Aircraft in Close Proximity to a Fixed Site Facility; Extension of Comment Period, 2026-06-30
- [2026-08943](https://policyrisk.com/federal-register/2026-08943): Designation-Restrict the Operation of Unmanned Aircraft in Close Proximity to a Fixed Site Facility, 2026-05-06
- [2025-04846](https://policyrisk.com/federal-register/2025-04846): Extension of the Prohibition Against Certain Flights in the Territory and Airspace of Libya, 2025-03-20
- [2025-03853](https://policyrisk.com/federal-register/2025-03853): Enforcement Policy Regarding “Drug and Alcohol Testing of Certificated Repair Station Employees Located Outside of the United States; Corre…, 2025-03-11

## Sources
- [2026-08106 on federalregister.gov](https://www.federalregister.gov/documents/2026/04/24/2026-08106/airworthiness-directives-pratt-and-whitney-engines)
- [2026-08106 as published (PDF)](https://www.govinfo.gov/content/pkg/FR-2026-04-24/pdf/2026-08106.pdf)

## Related
- [Previous: 2026-08104, Schedules of Controlled Substances: Placement of MDMB-4en-PINACA in Schedule I](https://policyrisk.com/federal-register/2026-08104)
- [Next: 2026-08108, Puerto Rico State Plan; Operational Status Agreement; Change in Level of Federa…](https://policyrisk.com/federal-register/2026-08108)
- [All Federal Register documents](https://policyrisk.com/federal-register)

Source: PRIA, https://policyrisk.com/federal-register/2026-08106 (as of 2026-06-11).
