California Administrative Code

(a) Except as provided in subdivision (b), all abrasive blasting operations shall be conducted within a permanent building. (b) An abrasive blasting operation conducted under one or more of the following conditions is not required to be conducted within a permanent building: (1) …

(a) The ARB shall certify abrasives which comply with the performance standards set forth in subdivision (b) below. Any person who desires certification of an abrasive shall furnish to the ARB an adequate test sample, together with fees to defray the cost of testing. Each certifi…

(a) To determine whether the department has jurisdiction over the conduct about which a person seeks to complain, or the respondent against whom the person seeks to file a complaint, the department shall screen pre-complaint inquiries requesting investigation by conducting an int…

(a) Effective Date. (1) No later than November 19, 2002 each air pollution control and air quality management district must: (A) Implement and enforce the requirements of this section; or (B) Propose their own asbestos airborne toxic control measure as provided in Health & Safety…

(a) Definitions. For the purposes of this section, the following definitions shall apply: (1) “Acute care facility” means any facility currently licensed by the California Department of Health Services as a general acute care hospital (as defined in title 22, CCR, section 70005),…

(a) Upon approval by the District APCO, the following sources of data may be used in whole or part to demonstrate compliance with the emissions standards or requirements of sections 93115.6 through 93115.9: (1) off-road engine certification test data for the stationary diesel-fue…

(a) The following test methods shall be used to determine diesel PM, HC, NOx, CO and NMHC emission rates: (1) Diesel PM emission testing shall be done in accordance with one of the following methods: (A) California Air Resources Board Method 5 (ARB Method 5), “Determination of Pa…

Each part of this ATCM shall be deemed severable, and in the event that any part of this ATCM is held to be invalid, the remainder of this ATCM shall continue in full force and effect.

(a) Requirements. (1) Standards for Nonvehicular Diesel Fuel Used in Harborcraft in the South Coast Air Quality Management District (SCAQMD) Beginning January 1, 2006. Beginning January 1, 2006, California nonvehicular diesel fuel sold, offered for sale, or supplied within the SC…

(a) Purpose. The purpose of this section is to require the use of low sulfur marine distillate fuels in order to reduce emissions of particulate matter (PM), diesel particulate matter, nitrogen oxides, and sulfur oxides from the use of auxiliary diesel and diesel-electric engines…

(a) Purpose. The purpose of this control measure is to reduce emissions of toxic air contaminants from the use of incinerators aboard cruise ships and oceangoing ships. Specifically, this regulation prohibits cruise ships and oceangoing ships from conducting onboard incineration …

(a) Any person subject to this Control Measure who fails to comply with any provision, prohibition, limit, standard, criteria, or requirement in this Control Measure is subject to the penalties, injunctive relief, and other remedies specified in Health and Safety Code sections 38…

If any section, paragraph, subparagrah, sentence, clause, phrase, or portion of this Control Measure is held invalid, unconstitutional, or unenforceable by any court of competent jurisdiction, such portion shall be deemed as a separate, distinct, and independent provision, and su…

This subchapter sets forth the criteria and guidelines for preparing emission inventory plans and reports to develop site-specific inventories of air emissions of toxic substances, as required by the Air Toxics “Hot Spots” Information and Assessment Act of 1987 (the “Act”: Stats.…

This subchapter shall apply to any facility subject to the Air Toxics “Hot Spots” Information and Assessment Act of 1987, Health & Safety Code sections 44300-44394. Subject facilities shall comply with the provisions of the “Emission Inventory Criteria and Guidelines Report” incl…

(a) For the purposes of this article, the following definitions apply: “Activity level” means a measurable factor or parameter of a process that relates directly or indirectly to the emissions of an air pollution source during the period for which emissions are reported. Some exa…

(a) The owner or operator of a facility subject to this article, including those facilities that cease reporting pursuant to 93401(c), must retain records and documentation necessary to validate the data in the emissions report for a period of no less than five years, notwithstan…

This regulation does not preempt any more stringent requirements imposed by any air district. Compliance with this article does not excuse noncompliance with any Federal regulation. The Executive Officer retains authority to determine whether an air district requirement is more s…

(a) Any person who cannot comply with the requirements set forth in section 94522, because of extraordinary reasons beyond the person's reasonable control may apply in writing to the Executive Officer for a variance. The variance application shall set forth: (1) the specific grou…

The certification of gasoline vapor recovery systems at dispensing facilities using aboveground storage tanks shall be accomplished in accordance with the California Air Resources Board's CP-206, “Certification Procedure for Vapor Recovery Systems at Gasoline Dispensing Facilitie…

The test method for determining nitrogen oxide emissions is set forth in the Air Resources Board's Method 7, Determination of Nitrogen Oxide Emissions from Stationary Sources, adopted June 29, 1983, as last amended July 28, 1997, which is incorporated herein by reference.

The test method for determining particulate beryllium emissions is set forth in the Air Resources Board's Method 104, Determination of Beryllium Emissions from Stationary Sources, adopted June 29, 1983, as amended March 28, 1986.

The test method for determining vinyl chloride emissions from ethylene dichloride, vinyl chloride and polyvinyl chloride manufacturing processes is set forth in the Air Resources Board's Method 106, Determination of Vinyl Chloride Emissions from Stationary Sources, adopted June 2…

The test method for determining hydrocarbon emissions from fixed-roof crude oil process tanks is set forth in the Air Resources Board's Method 150, Determination of Hydrocarbon Emissions from Fixed-Roof Crude Oil Process Tanks, adopted March 28, 1986.

The test method for determining low concentrations of benzene from stationary sources is set forth in the Air Resources Board's Method 410A, Low Concentration Gas Chromatographic Determination of Benzene from Stationary Sources, adopted March 28, 1986.

The test procedure for determining polycyclic aromatic hydrocarbon emissions is set forth in the Air Resources Board's Method 429, Determination of Polycyclic Aromatic Hydrocarbon (PAH) Emissions from Stationary Sources, adopted September 12, 1989, as last amended July 28, 1997, …

The test method for determining formaldehyde and acetaldehyde in emissions from stationary sources is set forth in the Air Resources Board's Method 430, Determination of Formaldehyde and Acetaldehyde in Emissions from Stationary Sources, adopted September 12, 1989, as last amende…

(a) Except as provided in sections 94510 (Exemptions), 94511 (Innovative Products), 94514 (Variances), and 94540 through 94555 (Alternative Control Plan), title 17, California Code of Regulations, no person shall sell, supply, offer for sale, or manufacture for sale in California…

The test method for determining the dynamic pressure performance of Phase II vapor recovery systems of dispensing facilities is set forth in the Air Resources Board's TP-201.4 “Dynamic Back Pressure” which is incorporated herein by reference. (Adopted: April 12, 1996, as last ame…

The test method for determining the air to liquid volume ratio of Phase II gasoline vapor recovery systems of dispensing facilities is set forth in the Air Resources Board's TP-201.5, “Air to Liquid Volume Ratio” which is incorporated herein by reference. (Adopted: April 12, 1996…

The compliance test method for determining the liquid blockage of a Phase II vapor recovery system is set forth in the Air Resources Board's TP-201.6C, “Compliance Determination of Liquid Removal Rate” which is incorporated herein by reference. (Adopted: July 3, 2002)

The test method for determining the bend radius for underground storage tank vapor return piping is set forth in the Air Resources Board's TP-201.2G, “Bend Radius Determination for Underground Storage Tank Vapor Return Piping,” adopted October 8, 2003, as last amended May 25, 200…

(a) Applications for variances. Any person who cannot comply with the requirements set forth in Section 94509 because of extraordinary reasons beyond the person's reasonable control may apply in writing to the Executive Officer for a variance. The variance application shall set f…

Any DG Unit that was purchased or leased while the DG Unit was certified can continue to be operated by the owner or lessee after the certification has expired so long as the DG Unit meets the standard to which it was certified.

(a) On or after January 1, 2003, any DG Unit subject to this regulation must be certified pursuant to section 94204 to one of the following sets of emission standards in Table 1. (1) DG Unit not integrated with combined heat and power, (2) DG Unit integrated with combined heat an…

(a) Each application for certification and the fee as specified in section 94210 shall be submitted in a format approved by the Executive Officer and include, at a minimum, the following information: (1) name of the Applicant, a contact person, mailing address (street and electro…

(a) This article shall not apply to any person who manufactures antiperspirants or deodorants in California for shipment and use outside of California. (b) The requirements of Section 94502(a) shall not apply to fragrances and colorants up to a combined level of 2 percent by weig…

(a) Labeling. (1) No later than three months after the effective date of this article, each manufacturer of an antiperspirant or deodorant subject to this article shall clearly display on each container of antiperspirant or deodorant, the date on which the product was manufacture…

(a)(1) VOC and GWP compound content determination using CARB Method 310. Testing to determine compliance with the requirements of this article, shall be performed using California Air Resources Board Method 310, Determination of Volatile Organic Compounds (VOC) in Consumer Produc…

(a) The Executive Officer shall take appropriate action on an ACP within the following time periods: (1) Within 30 working days of receipt of an ACP application, the Executive Officer shall inform the applicant in writing that either: (A) the application is complete and accepted …

(a) All information specified in the Executive Order approving an ACP shall be maintained by the responsible ACP party for a minimum of three years after such records are generated. Such records shall be clearly legible and maintained in good condition during this period. (b) The…

(a) Any person who commits a violation of this article is subject to the penalties specified in Health and Safety Code, section 42400 et seq. Failure to meet any requirement of this article or any condition of an applicable Executive Order shall constitute a single, separate viol…

(a) At the end of each compliance period, the responsible ACP party shall make an initial calculation of any shortfalls occurring in that compliance period, as specified in the Executive Order approving the ACP. Upon receipt of this information, the Executive Officer shall determ…

(a) Except as provided in Section 94803 (Exclusions and Exemptions), in accordance with any applicable phase-in provision in subdivision (b), no person shall manufacture for use in California, or sell, supply, offer for sale, or introduce into commerce, any indoor air cleaning de…

(a) Each manufacturer of an indoor air cleaning device subject to Section 94802 is required to submit an application for certification to the CARB Executive Officer, P.O. Box 2815, Sacramento, CA 95812, Attn: Indoor Air Cleaning Device Certification. The application may also be s…

(a) For the purpose of compliance with this regulation only a single model of an indoor air cleaning device within a model group, if one exists, must be evaluated under the test methods. (b) Testing of indoor air cleaning devices to determine compliance with the requirements of t…

Within 12 months of the effective date of this regulation, manufacturers of uncertified indoor air cleaning devices manufactured, sold, supplied, offered for sale, or introduced into commerce in California must submit documentation that they have provided to all of their known di…

The operator of a facility who is required to report under section 95101 of this article, and who is not eligible for abbreviated reporting under section 95103(a), must comply with Subpart H of 40 CFR Part 98 (§§ 98.80 to 98.88) in reporting annual stationary combustion and proce…

The electric power entity who is required to report under section 95101 of this article must comply with the following requirements. (a) General Requirements and Content for GHG Emissions Data Reports for Electricity Importers and Exporters. (1) Greenhouse Gas Emissions. The elec…

§ 100.30. Forms. [Repealed] This database is current through 5/1/26 Register 2026, No. 18. Source: https://govt.westlaw.com/calregs/Document/I506C82535A1E11EC8227000D3A7C4BC3?viewType=FullText&originationContext=documenttoc&transitionType=CategoryPageItem&contextData=(sc.Default)