California Administrative Code

(a) The evisceration registration issued under this part is valid for one calendar year from the date issued. (b) A renewal application must be submitted prior to the expiration date. (c) The Department may revoke or suspend an evisceration registration for noncompliance with app…

The state board shall classify districts by the following categories for the purpose of establishing evaluation criteria based on the factors set forth in Section 39806(b) of the Health and Safety Code. (a) “Large urban districts”; (b) “Small urban districts”; (c) “Rural resource…

(a) It is unlawful for a person to give away, donate, sell, or offer for sale uneviscerated crab harvested from an area under a Department Evisceration Order except to an approved processor. (b) It is unlawful for an approved processor to receive, hold, or eviscerate crab from an…

A large confined animal facility shall mean: (a) In any area designated as a federal ozone nonattainment area as of January 1, 2004, any confined animal facility that maintains on any one day: (1) 1,000 or more milk-producing dairy cows; (2) 3,500 or more beef cattle; (3) 7,500 o…

(a) “Coordinated subvention” means a subvention authorized by Section 39802 of the Health and Safety Code. Such a subvention may be granted to a district participating in a coordinated basinwide program. A district satisfying either of the following conditions will be considered …

The state board staff shall develop in cooperation with the districts and the state board shall adopt evaluation criteria for each category established in Section 90120 which are appropriate to determine, in accordance with Section 39806 of the Health and Safety Code, whether dis…

(a) Except for facilities exempted by Health and Safety Code Section 44324, 44344.4(a), or 44380.1 this regulation applies to any facility which: (1) manufactures, formulates, uses, or releases any of the substances listed by the State Board pursuant to Health and Safety Code Sec…

(a) The State Board shall adopt a regulation for fiscal year 2001-2002 which meets the requirements of Health and Safety Code Section 44380(a). Districts whose fee schedules are included in this regulation under Section 90704(b) are subject to the provisions of subdivisions (d)-(…

(a) No later than 180 days after the operative date of this section, each district identified below shall transmit the dollar amount specified below to the Board for deposit into the Air Pollution Control Fund. The amount transmitted shall be collected from facilities which are t…

(a) No later than 180 days after the operative date of this section, each district identified below shall transmit the dollar amount specified below to the Board for deposit into the Air Pollution Control Fund. The amount transmitted shall be collected from facilities which are t…

(a) No later than 180 days after the operative date of this section, each district identified below shall transmit the dollar amount specified below to the Board for deposit into the Air Pollution Control Fund. The amount transmitted shall be collected from facilities which are t…

(a) Notwithstanding the provisions of sections 90800.8 and 90802, each district shall have the option for any fiscal year to collect fees from facilities within the district instead of having the state board collect the fees. A district that chooses to collect fees from facilitie…

Local registrars and county recorders may match deaths occurring in their jurisdictions to births registered in their office and, for any registrants thereby identified as deceased, make any of the notations specified in Section 910(a) (1) and (2).

The Executive Officer of the Air Resources Board (State Board) or his or her authorized representative may, upon reasonable written notice, require the owner or operator of any substance, article, machine, equipment, or other contrivance, the use of which may cause the issuance o…

(a) The fee schedules in this Subchapter shall not supersede or preempt any rule or regulation of any air pollution control district governing fees for source testing. (b) The following definitions apply for the purposes of this subchapter only. (1) “Source” means (i) any permit …

Credits that are used interchangeably shall be certified and registered as pounds of pollutant in one year increments.

(a) Where test results indicate that a source is in compliance with permit conditions or with any State or local law, order, rule or regulation relating to air pollution, the responsible party shall be assessed the applicable fees in Section 91201 only once per each 12-month peri…

(a) After completion of testing conducted by the State Board directly or by a contractor to the State Board, the responsible party shall be notified by the Accounting Office of the State Board, in writing, of the fees to be paid for such tests and of preliminary results. The fail…

(a) The responsible party may petition the Executive Officer, no later than 30 days after receipt of the fee notice described in Section 91203, to be excused from payment of fees, or a portion of such fees, on the grounds that payment of such fees would cause a demonstrable finan…

(a) A small business shall not be required to pay any fees otherwise applicable under Section 91201. A “small business,” for the purposes of this section, shall be as defined in subsection (1), Section 1896, Title 2 of the California Administrative Code. (b) Any responsible party…

Without prior approval of the Executive Officer, the independent tester shall not disclose to the responsible party or the responsible party's personnel in advance of the test the dates, locations, or times of testing. The independent tester shall not disclose to the responsible …

All original records made during testing requested by the State Board shall become the property of the State Board. All or part of such records may be requested by the Executive Officer at any time during or after the test period. All original records and the report of results fr…

For the purposes of this subchapter: (a) “Abrasives” means any material used in abrasive blasting operations including but not limited to sand, slag, steel shot, garnet or walnut shells. (b) “Abrasive blasting” means the operation of cleaning or preparing a surface by forcibly pr…

These standards in this subchapter are not intended to prohibit air pollution control districts from enforcing their permit regulations as they apply to abrasive blasting equipment.

(a) No person shall, discharge into the atmosphere from any abrasive blasting which is conducted outside a permanent building any air contaminant for a period or periods aggregating more than three minutes in any one hour which is: (1) As dark or darker in shade as that designate…

No person shall conduct any abrasive blasting operation without complying with the performance standards described in article 4.

(a) Except as provided in subdivision (b), all abrasive blasting operations shall be conducted within a permanent building. (b) An abrasive blasting operation conducted under one or more of the following conditions is not required to be conducted within a permanent building: (1) …

(a) The ARB shall certify abrasives which comply with the performance standards set forth in subdivision (b) below. Any person who desires certification of an abrasive shall furnish to the ARB an adequate test sample, together with fees to defray the cost of testing. Each certifi…

(a) To determine whether the department has jurisdiction over the conduct about which a person seeks to complain, or the respondent against whom the person seeks to file a complaint, the department shall screen pre-complaint inquiries requesting investigation by conducting an int…

Each substance listed in this section has been identified as a hazardous air pollutant pursuant to subsection (b) of Section 112 of the federal Clean Air Act (42 U.S.C. Section 7412(b)) and has been designated by the State Board to be a toxic air contaminant pursuant to Health an…

The nonvehicular airborne toxic control measures contained in this subchapter have been adopted by the state board and shall be implemented by adoption of regulations by local air pollution control and air quality management districts pursuant to Health and Safety Code Section 39…

(a) Applicability This Airborne Toxic Control Measure (ATCM) shall apply to each thermal spraying operation at a stationary source that uses materials containing chromium, chromium compounds, nickel, or nickel compounds. This ATCM does not apply to portable thermal spraying opera…

The Airborne Toxic Control Measure for Chromium Electroplating and Chromic Acid Anodizing Operations (ATCM) is contained in sections 93102 through 93102.16.

(a) No Person shall sell, supply, offer for sale, or manufacture for sale in California, any Chrome Plating Kit. (b) No person in California shall use a Chrome Plating Kit to perform Chrome Plating.

This section 93102.16 contains Appendices 1 through 9 to the ATCM for Chromium Electroplating and Chromic Acid Anodizing Operations. All documentation submitted to CARB or the District pursuant to this ATCM shall: 1. Be written in the English language; 2. Contain the following st…

This section sets forth requirements that apply to all Facilities using Hexavalent Chromium for Chrome Plating Operations. (a) Removal of Add-on Air Pollution Control Device(s). No Add-on Air Pollution Control Device(s) installed on a Hexavalent Chromium Containing Tank shall be …

The Air Toxic Control Measure (ATCM) for Stationary Compression Ignition (CI) Engines is set forth in sections 93115 through 93115.15, title 17, California Code of Regulations.

(a) Reporting Requirements for Owners or Operators of New and In-Use Stationary CI Engines, Including Non-Diesel-Fueled CI Engines, Having a Rated Horsepower Greater than 50 (> 50 bhp). (1) Except as provided in section 93115.3 and section 93115.10(a)(5) below, prior to the insta…

(a) All owners and operators of three or fewer engines located within a District, who will meet the requirements of sections 93115.6(b) solely by maintaining or reducing the current annual hours of operation for maintenance and testing, shall be in compliance with the annual hour…

(a) For purposes of this ATCM, the following definitions apply: (1) “Agricultural Operations” means the growing and harvesting of crops or the raising of fowl or animals for the primary purpose of making a profit, providing a livelihood, or conducting agricultural research or ins…

(a) Requirements. (1) Standards for Nonvehicular Diesel Fuel Used in Harborcraft in the South Coast Air Quality Management District (SCAQMD) Beginning January 1, 2006. Beginning January 1, 2006, California nonvehicular diesel fuel sold, offered for sale, or supplied within the SC…

(a) Purpose. The purpose of this section is to require the use of low sulfur marine distillate fuels in order to reduce emissions of particulate matter (PM), diesel particulate matter, nitrogen oxides, and sulfur oxides from the use of auxiliary diesel and diesel-electric engines…

(a) Purpose. The purpose of this control measure is to reduce emissions of toxic air contaminants from the use of incinerators aboard cruise ships and oceangoing ships. Specifically, this regulation prohibits cruise ships and oceangoing ships from conducting onboard incineration …

The following documents are incorporated by reference in this airborne toxic control measure: (a) ANSI A135.4-2004. American National Standard -- Basic Hardboard, 2004. (b) ANSI A135.5-2004. American National Standard -- Prefinished Hardboard Paneling, 2004. (c) ANSI A135.6-2006.…

This section contains Appendices 1-3 to the Airborne Toxic Control Measure to Reduce Formaldehyde Emissions from Composite Wood Products. (a) Sell-through Dates that Apply to Manufacturers of Hardwood Plywood (HWPW), Particleboard (PB), and Medium Density Fiberboard (MDF). (1) Se…

(a) All third party certifiers must be approved in writing by the ARB Executive Officer as provided in subsection (b). The Executive Officer will issue a number to each approved third party certifier. (b) ARB Approval of Third Party Certifiers. (1) Applications to become an ARB-a…

(a) Emission Standards. Except as provided in the “sell-through” provisions of section 93120.12, Appendix 1, all importers must comply with the requirements of section 93120.2(a) for all composite wood products and finished goods containing these materials that are sold, supplied…

(a) Compliance Test Methods for HWPW, PB, and MDF. Compliance with the emission standards for HWPW, PB, and MDF in section 93120.2(a) and, if applicable, section 93120.3(c) or (d) shall be demonstrated by conducting product emissions tests, verified by third party certification a…

The Control Measure for Ocean-Going Vessels At Berth is set forth in sections 93130 through 93130.22, title 17, California Code of Regulations, and is referenced as the “Control Measure” within those sections. The Control Measure is designed to supersede section 93118.3 of title …

§ 1274.05. Intersecting Roads, Streets and Private Lanes. [Repealed] This database is current through 5/1/26 Register 2026, No. 18. Source: https://govt.westlaw.com/calregs/Document/I4733337A5B4D11EC976B000D3A7C4BC3?viewType=FullText&originationContext=documenttoc&transitionType=…