New Mexico Administrative Code

Electrical device installation shall comply with accessibility codes adopted for New Mexico.

Outdoor lighting shall comply with the Night Sky Protection Act 74-12-1 through 74-12-11 NMSA 1978.

This rule applies to all contracting work performed in New Mexico on or after March 28, 2023 that is subject to the jurisdiction of CID, unless performed pursuant to a permit for which an application was received by CID before that date.

See 14.7.6 NMAC, the 2018 New Mexico residential energy conservation code.

See 14.7.9 NMAC, the 2018 New Mexico commercial energy conservation code.

Section 60 -13-9 NMSA 1978.

Permanent.

March 28, 2023, unless a later date is cited at the end of a section.

The purpose of this rule is to establish minimum standards for electrical wiring, as defined in CILA Section 60-13-32 NMSA 1978, in New Mexico.

A. This rule adopts by reference the 2020 National Electrical Code (NEC), as amended by this rule. B. In this rule, each provision is numbered to correspond with the numbering of the 2020 National Electrical Code. C. This rule is to be applied in conjunction with 14.7.6 NMAC, the…

A. Inspectors. See 14.6.5 NMAC, Inspectors. B. Disconnect orders. See CILA Section 60-13-42. C. Stop orders. See 14.5.3 NMAC, Inspections. D. Unsafe wiring. See 14.5.1 NMAC, General Provisions. E. Electrical plan review. See 14.5.2 NMAC, Permits. F. Electrical permit. See 14.5.2 …

Construction Industries Division of the Regulation and Licensing Department.

See these sections of the NESC.

See these sections of the NESC.

This rule applies to all contracting work performed on all customer-owned electrical distribution and transmission facilities in New Mexico, on or after July 1, 2004, that are subject to the jurisdiction of CID, unless performed pursuant to a permit for which an application was r…

NMSA 1978 Section 60-13-9 and 60-13-44.

Permanent.

August 1, 2014, unless a later date is cited at the end of a section.

The purpose of this rule is to establish minimum standards for contracting work performed on all customer-owned electrical distribution and transmission facilities in New Mexico.

[Reserved]

A. This rule adopts by reference the 2012 national electrical safety code, as amended by this rule. B. In this rule, each provision is numbered to correspond with the numbering of the 2012 national electrical safety code.

A. 010. Purpose. See this section of the NESC and add the following new subsections: E. Electrical customer-owned distribution systems are subject to the NMESC. Customer-owned distribution systems include all (non-utility owned or operated) overhead or underground primary or seco…

The Construction Industries Division of the Regulation and Licensing Department.

This rule applies to all persons engaged in the construction activities, including inspectors and code enforcement officials, in the state of New Mexico. 14 NMAC 11.3 [now 14.11.3 NMAC] has a broad scope, with provisions that apply to the erection, installation, alteration, addit…

A. Pursuant to Section 60-13-9(F) of the Construction Industries Licensing Act, NMSA 1978, the construction industries division of the regulation and licensing department has adopted 14 NMAC 11.3 [now 14.11.3 NMAC]. This section provides as follows: "The division shall adopt all …

Permanent, until later amended, repealed or replaced.

December 31, 1998 unless a later date is cited at the end of a section or paragraph.

The objective of 14 NMAC 11.3 [now 14.11.3 NMAC] is to promote the general welfare of the people of the state of New Mexico by providing for the protection of life and property through standards that, when complied with, will result in an installation essentially free from hazard…

[RESERVED]

Adoption of the 1997 Uniform Plumbing Code (14 NMAC 11.3) [now 14.11.3 NMAC] was recommended by the mechanical bureau and formally approved by the construction industries commission on August 17, 1998. A. This part supersedes Rule No. MB-UPC-91-1, the 1991 Uniform Plumbing Code, …

The Manufactured Housing Division of the Regulation and Licensing Department.

A. The division adopts as part of these rules the following federal statutes and regulations as minimum standards for new manufactured home construction and installation: (1) Manufactured Home Construction and Safety Standards Act of 1974, as amended by the National Manufactured …

A. Manufactures, brokers, dealers and salespersons licensed under the Manufactured Housing Act must post a "notice to the public" poster at their place of business. The poster must be located by the main door entrance or a location within full reading view of the public. B. The p…

A. Any dealer, salesperson, or broker who receives any consideration for arranging the transfer of equity or the assumption of a loan on a manufactured home shall ascertain whether such manufactured home has a lien or security interest filed on it with the motor vehicle division …

A. A licensee shall adequately supervise and control employees. The failure of a licensee to undertake appropriate corrective action within a reasonable period of time after the licensee has actual knowledge of a violation of the act or these rules shall be prima facie proof of i…

A. Licenses are not transferable. B. A licensee must notify the manufactured housing division immediately of any change in the licensee's name, business name, mailing or business address, business entity or structure, business ownership, place of business or employment. C. Upon r…

A. The licensee's name and licensee number shall be included in advertising and on all vehicles used in conjunction with the installation and repair of manufactured homes in the licensee's business. Letters and numbers on licensee's service vehicles shall be no less than two (2) …

A. Requests for inspection of records are governed by the Inspection of Public Records Act (NMSA 1978, Section 14-2-1 et. seq.). B. The division director shall appoint a custodian of public records. The custodian may require that a request for inspection of records be in writing …

A. All installations of residential manufactured homes must comply with the Manufactured Housing Act, all rules adopted by the division and all locally adopted zoning and planning requirements. B. Prior to delivery of a manufactured home every dealer shall have the consumer sign …

If any section of these rules is held to be inoperative, invalid or illegal, the remaining provisions shall continue in effect and operation.

These rules apply to all manufacturers, dealers, brokers, salesman, installers, repairman, contractors, and purchasers of manufactured homes in the state of New Mexico.

These rules are promulgated pursuant to the Manufactured Housing Act, Sections 60-14-1 through 60-14-20.

Permanent.

12-01-10 unless a later date is cited at the end of a section.

The objective of 14.12.1 NMAC is to set forth the general provisions, which apply to Part 1, Part 2 and Part 4 through Part 11 of Chapter 12, and to all persons affected or regulated by Part 1, Part 2 and Part 4 through Part 11 of Chapter 12 of Title 14.

All words and terms defined in the Manufactured Housing Act have the same meaning in these rules. A. Terms starting with the letter 'A' are defined as follows.(1) "Act" means the Manufactured Housing Act. Chapter 60, Article 14, Section 4, NMSA, 1978 is incorporated herein and ma…

Ordinances of any political subdivision of New Mexico relating to gas, including natural gas, liquefied petroleum gas or synthetic natural gas; electricity; sanitary plumbing; and installation or sale of manufactured homes shall not be inconsistent with any rules, regulations, co…

A. Rules are adopted by the division to further define the Manufactured Housing Act and the functions of the manufactured housing committee and the division. B. Prior to adoption of rules, amendments to rules or repeal of rules the division or commitee shall hold a public hearing…

The Manufactured Housing Division of the Regulation and Licensing Department.