New Mexico Administrative Code

The commission has adopted the following publications as the rules for construction, installation, operation, inspection, repair and alterations of all existing boilers. A. Uniform Plumbing Code, 1991 Edition, 14 NMAC 11.3 (MB-UPC-91-1) [now 14.11.3 NMAC]. B. Uniform Mechanical C…

A. It shall be unlawful to install or reinstall any boiler without first obtaining a permit to do so from the mechanical bureau, subject to all provisions of the construction industries division rules and regulations. B. Owner/user inspectors are not required to have permits issu…

The Construction Industries Division of the Regulation and Licensing Department.

A. A journeyman shall take a division approved medical gas and vacuum systems re-certification training course every three years. The journeyman must also be qualified as per section IX of the ASME Boiler and Pressure Vessel Code or AWS B2.2 and maintain the brazing qualification…

An apprentice, as that term is defined in CILA Section 60-13-2 NMSA 1978, may work under the direct supervision of a validly certified journeyman, holding a JP, JG, JPG, or JPF and who also holds an active medical gas certification pursuant to this regulation and who is under the…

A. State and local building inspectors inspecting medical gas and vacuum piping systems shall be division approved certified plumbing inspectors pursuant to 14.6.5.8 NMAC and shall also meet the requirements of ASSE 6020 professional qualification standard for medical gas and vac…

A. Medical gas and vacuum systems shall be verified by third-party verifiers who meet the requirements of ASSE 6030 professional qualification standard for medical gas and vacuum system verifiers and Chapter 13 of the current adopted NMPC; B. In addition to these requirements med…

A. Permits required for medical gas and vacuum systems shall be pursuant to 14.5.2 NMAC. B. Plans and document submittals for medical gas and vacuum systems shall be pursuant to 14.5.2.10 NMAC. C.Inspections for medical gas and vacuum piping systems shall be as follows: (1) State…

A. All medical gas and vacuum piping systems shall be installed in compliance with Chapter 13 of the current adopted NMPC, NFPA 99, current adopted 14.9.5 NMAC and ASSE 6000. B. A dental office, as defined in the NFPA 99, that administers piped nitrous oxide, shall comply with th…

All individuals installing a medical gas and vacuum system shall comply with all applicable codes, standards, rules and regulations adopted by the construction industries division, and shall be subject to possible revocation or suspension of their licenses and certificates of com…

This rule shall apply to all individuals installing, altering, repairing, servicing, verifying, inspecting and maintaining medical gas and vacuum systems in Category 1,2 and 3 medical gas and medical vacuum piping systems in health care facilities.

Construction Industries Licensing Act (CILA) Sections 60-13-9 and 60-13-44 NMSA 1978.

Permanent.

11/15/2019, unless a later date is cited at the end of a section.

The objective of 14.9.5 NMAC is to promote the general welfare of the people of New Mexico by providing for the protection of life and property through the adoption and enforcement of the current adopted New Mexico Plumbing Code, 14.8.2 NMAC.

A. "ASME" means American Society of Mechanical Engineering. B. "ASSE" means American Society of Sanitary Engineers. C. "Direct supervision" means reasonable oversight, inspection and evaluation of the work of a person by constant on the jobsite supervision by a certified journeym…

A. Medical gas and vacuum systems installations, alterations, repairs, service and maintenance shall be performed by a properly New Mexico certified journeyman plumber (JP), journeyman gasfitter (JG), journeyman plumber-gasfitter (JPG) or journeyman pipefitter (JPF) who meets the…

Construction Industries Division (CID) of the Regulation and Licensing Department.

See this chapter of the USEC, except as provided below. A. 207.0 "E" - Existing work. Delete the text of definition and see section 102.0 of the Uniform Mechanical Code (UMC). B. 215.0 "M" - Mechanical code. Delete the text of this definition and see section 14.5.1 NMAC. C. 218.0…

See this chapter of the USEC except as follows: 305.1 Dissimilar metals. See this section of the USEC except delete "of open loop systems" in the last sentence.

See this chapter of the USEC except as follows: 402.1.8 Freeze protection. See this section of the USEC except delete the first sentence and substitute with the following: No solar thermal piping containing heat transfer fluid that is capable of freezing under normal conditions s…

See this chapter of the USEC.

See this chapter of the USEC.

See this chapter of the USEC.

See this chapter of the USEC.

See this chapter of the USEC.

Delete this chapter of the USEC and see 14.10.4 NMAC.

See this chapter of the USEC.

This rule applies to all contracting work performed in New Mexico on or after May 1, 2015, that is subject to the jurisdiction of CID, unless performed pursuant to a permit for which an application was received by CID before that date.

See this chapter of the USEC.

See this chapter of the USEC, except delete appendix b and appendix c.

Section 60-13-9 and 60-13-44 NMSA 1978.

Permanent.

May 1, 2015, unless a later date is cited at the end of a section.

The purpose of this rule is to establish minimum standards for the construction of all solar energy systems in New Mexico.

See 14.5.1 NMAC, General Provisions and Chapter 2 of the 2012 Uniform Solar Energy Code (USEC) as amended in 14.9.6.10 NMAC.

A. This rule adopts by reference the 2012 USEC and all appendices, as Adopted by this rule. B. In this rule, the internal numbering of each provision corresponds with the numbering of the 2012 USEC. C. This rule is to be applied in conjunction with all the other 2009 New Mexico b…

A. 101.0 General. (1) 101.1 Title. Delete this section of the USEC and substitute: This code shall be known as the 2009 New Mexico solar energy code (NMSEC). (2) 101.2 Scope. Delete this section of the USEC and see 14.9.6.2 NMAC. (3) 101.3 Purpose. Delete this section of the USEC…

New Mexico Gaming Control Board.

This rule applies to all parties seeking to furnish property and/or services to the New Mexico Gaming Control Board and includes references to regulations and guidelines issued by the General Services Department and to Sections 13-1-74 and 13-1-93 of the Procurement Code.

Authority for this rule derives from the Gaming Control Act [Sections 60-2E-1 to 60-2E-61 NMSA 1978] and the Procurement Code [Sections 13-1-28 to 13-1-117 and 13-118 to 13-1-199 ].

Permanent.

September 15, 1998, unless a later date is cited at the end of a section.

The objectives of this rule are to notify potential contractors of the procedures and requirements for furnishing property and/or services to the Gaming Control Board.

Unless otherwise defined below, terms in this rule have the same meanings as set forth in the Gaming Control Act: A. "board" means the New Mexico Gaming Control Board. B. "contractor" means any party submitting a bid, proposal, and/or quote to the board for the furnishing of prop…

The Board shall procure all property and services in accordance with the regulations and guidelines issued by the General Services Department unless, pursuant to the Procurement Code, the Board elects to adopt its own regulations for procurement of items exempted from the State P…

Pursuant to Section 60-2E-8(C)(17) of the Gaming Control Act, all procurement by the Board of personal property valued in excess of twenty thousand dollars ($20,000) shall be made pursuant to General Services Department Regulations and published guidelines and the Procurement Cod…

New Mexico Gaming Control Board.

The board may revoke or suspend the license, work permit, or finding of suitability of a person convicted of a felony, regardless of whether that person has exhausted his or her post-conviction rights and remedies.