New Mexico Administrative Code

November 30, 1995. [The latest effective date of any section in this Part is 10/31/02.]

The objective of this Part is to establish particulate matter emission standards for asphalt process equipment.

In addition to the terms defined in 20.2.2 NMAC (Definitions), as used in this Part: A. "Part" means an air quality control regulation under Title 20, Chapter 2 of the New Mexico Administrative Code, unless otherwise noted; as adopted or amended by the Board. B. "Rural area" mean…

This Part amends and supersedes Air Quality Control Regulation ("AQCR") 501 -- Asphalt Processing Equipment last filed July 1, 1971. A. All references to AQCR 501 in any other rule shall be construed as a reference to this Part. B. The amendment and supersession of AQCR 501 shall…

Environmental Improvement Board.

The owner or operator of equipment for gypsum processing shall not permit, cause, suffer or allow particulate matter emissions in excess of the 690 mg/m3 of exhaust gas.

All geographic areas within the jurisdiction of the Environmental Improvement Board.

Environmental Improvement Act, NMSA 1978, section 74-1-8(A)(4) and (7), and Air Quality Control Act, NMSA 1978, sections 74-2-1 et seq., including specifically, section 74-2-5(A), (B) and (C).

Permanent.

November 30, 1995. [The latest effective date of any section in this Part is 10/31/02.]

The objective of this Part is to establish particulate matter emission standards for gypsum processing plants.

In addition to the terms defined in 20.2.2 NMAC (Definitions), as used in this Part: "Part" means an air quality control regulation under Title 20, Chapter 2 of the New Mexico Administrative Code, unless otherwise noted; as adopted or amended by the Board.

This Part amends and supersedes Air Quality Control Regulation (AQCR) 503 -- Gypsum Processing Plants last filed January 27, 1970. A. All references to AQCR 503 in any other rule shall be constructed as a reference to this Part. B. The amendment and supersession of AQCR 503 shall…

Environmental Improvement Board.

All geographic areas within the jurisdiction of the Environmental Improvement Board.

A. The owner or operator of coal burning equipment having a rated heat capacity less than or equal to 250 million British Thermal Units per hour (higher heating value) shall not permit, cause, suffer or allow particulate matter emissions to the atmosphere to exceed the limits set…

The owner or operator of new coal burning equipment having a rated heat capacity greater than 250 million British Thermal Units per hour (higher heating value) shall not permit, cause, suffer, or allow: A. Particulate matter emissions to the atmosphere in excess of 0.05 pounds pe…

The owner or operator of existing coal burning equipment having a rated heat capacity greater than 250 million British Thermal Units and less than 5000 million British Thermal Units per hour (higher heating value) shall not permit, cause, suffer or allow: A. Particulate matter em…

After December 31, 1982, The owner or operator of existing coal burning equipment having a rated heat capacity equal to or greater than 5000 million British Thermal Units per hour (higher heating value) shall not permit, cause, suffer, or allow: A. Particulate matter emissions to…

Particulate matter emissions governed by 20.2.14.200 NMAC, and subsection A of 20.2.14.201 NMAC, subsection A of 20.2.14.202 NMAC, and subsection A of 20.2.14.203 NMAC, shall be determined by a method consistent with the method set forth by the US EPA at 40 CFR, Part 60, Appendix…

A. With regard to existing coal burning equipment having a rated heat capacity greater than 250 million British Thermal Units and less than 5000 million British Thermal Units per hour (higher heating value) or with regard to existing coal burning equipment having a rated heat cap…

Environmental Improvement Act, NMSA 1978, Section 74-1-8(A)(4) and (7), and Air Quality Control Act, NMSA 1978, Sections 74-2-1 et seq., including specifically, Section 74-2-5(A), (B) and (C).

A method is specified for use in sampling the emissions from stationary coal-burning equipment for particulate matter of less than two microns (2u) equivalent aerodynamic diameter. This procedure shall be used for testing emissions from coal-burning equipment operating in the Sta…

A. Principle: Particulate matter is withdrawn at an approximately isokinetic rate from the source, the large (over 2u) [over 2 micrometer] particles separated from the gas stream, and the fine particles collected on a filter. The weight of the fine particles is determined gravime…

Figure 1. Click to View Image

Figure 2. Click to View Image

Figure 3. Click to View Image

Figure 4. Click to View Image

Permanent.

A method is specified for use in sampling the emissions from stationary coal burning equipment for particulate matter of less than two microns (2u) equivalent aerodynamic diameter. This procedure shall be used for testing emissions from coal burning equipment in the State of New …

A. Principle: Particulate matter is withdrawn at an approximately isokinetic rate from the source. The particles are then separated by equivalent aerodynamic diameter by an in-stack size separating device to determine the percentage by mass of particles less than 2 microns equiva…

Figure 1. Click to View Image

Figure 2. Click to View Image

Figure 3. Click to View Image

Figure 4. Click to View Image

November 30, 1995. [The latest effective date of any section in this Part is 10/31/02.]

The objective of this Part is to establish particulate matter emission standards for coal burning equipment.

In addition to the terms defined in 20.2.2 NMAC (Definitions), as used in this Part: A. "Commenced" means that an owner or operator has undertaken a continuous program of construction or that an owner or operator has entered into a binding agreement or contractual obligation to u…

This Part amends and supersedes Air Quality Control Regulation ("AQCR") 504 -- Particulate Emissions from Coal Burning Equipment last filed June 13, 1978. A. All references to AQCR 504 in any other rule shall be construed as a reference to this Part. B. The amendment and superses…

Documents cited in this Part may be viewed at the New Mexico Environment Department, Air Quality Bureau, Harold Runnels Building, 1190 Saint Francis Drive, Santa Fe, NM, 87503 [2048 Galisteo St., Santa Fe, NM 87505].

Environmental Improvement Board.

A. The owner or operator of pumice, mica or perlite process equipment shall not permit, cause, suffer or allow particulate matter emissions to the atmosphere from a stack or stacks in excess of the maximum amounts specified in the following table: Process Rate Pounds per Hour Max…

Within technical feasibility, all particulate matter emissions to the atmosphere resulting directly from the operation of pumice, mica or perlite process equipment shall be limited to the stack outlet or outlets. Particulate matter emissions not governed by this section are gover…

The owner or operator of pumice, mica or perlite process equipment shall not permit, cause, suffer or allow any material to be handled, transported, stored or disposed of or a building or road to be used, constructed, altered or demolished without taking reasonable precautions to…

All geographic areas within the jurisdiction of the Environmental Improvement Board.

Environmental Improvement Act, NMSA 1978, section 74-1-8(A)(4) and (7), and Air Quality Control Act, NMSA 1978, sections 74-2-1 et seq., including specifically, section 74-2-5(A), (B) and (C).

Permanent.