FAA Accepts New ASTM Standards for Normal Category Airplanes
Published Date: 11/18/2026
Rule
Summary
The FAA is officially accepting new ASTM standards as a way to prove small airplanes meet safety rules starting November 18, 2026. This update helps airplane makers by giving clear, trusted guidelines to follow, speeding up certification and keeping costs in check. If you build or certify normal category airplanes, these changes affect you directly!
Analyzed Economic Effects
7 provisions identified: 2 benefits, 5 costs, 0 mixed.
Tighter Requirements for Rechargeable Lithium Batteries
For installations of rechargeable lithium batteries, the FAA requires meeting RTCA/DO-311A test procedures (including providing the FAA with the video of RTCA/DO-311A section 2.4.5.5 testing), demonstrates venting categories (B or C) per RTCA/DO-311A, and requires showing the battery installation can contain/vent thermal runaway and withstand a 2000 °F flame for 15 minutes per AC 20-135. Coin/button rechargeable cells under 2 watt-hours that meet UL 1642, UL 2054, or IEC 62133 are exempt from one rotor-burst/installation requirement.
ASTM F3264-25 Accepted as Part 23 MOC
The FAA accepts ASTM F3264-25, “Standard Specification for Normal Category Aeroplanes Certification,” as an FAA-accepted means of compliance (MOC) to 14 CFR part 23 (amendments 23-64 and 23-65). This acceptance is effective November 18, 2026 and covers the ASTM revisions referenced in F3264-25 with the FAA-identified changes.
Novel Designs Outside This MOC
Novel airplane designs (for example, unmanned airplanes or special class aircraft such as powered-lift) are beyond the scope of this NOA. If you design such a novel airplane, you must propose and obtain FAA acceptance of an alternative means of compliance in accordance with § 23.2010.
Electric Propulsion and Highly Integrated Systems Need FAA Coordination
For normal category airplanes with electric propulsion, fly-by-wire flight controls, or highly integrated systems, applicants must coordinate with the FAA Policy and Standards Division to determine airworthiness criteria and acceptable compliance approaches. Certain ASTM standards for electric or hybrid-electric systems are not universally accepted and must be proposed and accepted project-by-project under § 23.2010.
FAA-Required Editorial and Technical Changes to ASTM Standards
The FAA requires specific edits to many ASTM standards to be accepted as an MOC—for example, replacing instances of “should” with “must” in F2490-20, changing certain assumptions (e.g., ‘assume “night” conditions’ replaced by worst-case based on system criticality), and numeric probability thresholds updated (e.g., to 10^-5, 10^-8, 10^-9). These changed provisions become part of the FAA-accepted MOC.
Seaplane/Amphibian Buoyancy MOC Not Included
ASTM F3061/F3061M-25 does not contain a means for showing compliance with § 23.2310 (Buoyancy for seaplanes and amphibians). If you apply for certification of a seaplane or amphibian, you may use §§ 23.751, 23.755, and 23.757 at amendment 23-63 to comply with § 23.2310 or obtain FAA acceptance of a different MOC under § 23.2010.
NOA Is Guidance and Voluntary
This Notification of Availability is a guidance document and is not legally binding on its own. Conforming with the guidance is voluntary, and not following it will not by itself change rights or obligations under existing statutes and regulations.
Personalized for You
How does this regulation affect your finances?
Personalize government policy and PRIA will tell you what this federal register document means for your household, plus every other regulation we track. PRIA reads each provision against your financial profile to show you exactly what matters to your wallet.
Key Dates
Department and Agencies
Related Federal Register Documents
2026-15585, Requirements for Interference-Tolerant Radio Altimeter Systems
In July 2025, President Trump signed the One Big Beautiful Bill Act. Section 40002 of that law re-institutes the Federal Communications Commission's general auction authority and specifically directs the Commission to complete a system of competitive bidding for not less than 100 megahertz in the 3.98-4.2 gigahertz band (Upper C- band). This final rule supports the Federal Communications Commission's July 2026 Report and Order that makes 160 megahertz of the Upper C-band available for terrestrial wireless flexible use via a system of competitive bidding. To ensure safe, efficient, and reliable aviation operations in the presence of wireless signals in the C-band, the Federal Aviation Administration is issuing new regulations that require all radio altimeters to meet specific minimum performance requirements. These new radio altimeters must withstand interference from wireless signals in neighboring spectrum bands and continue to provide accurate altitude readings to both pilots and integrated aircraft safety systems. These regulations require all aircraft equipped with radio altimeters operating under part 121 and those aircraft with radio altimeters operating under part 129 with 30 or more passenger seats or a payload capacity of more than 7,500 pounds to comply with the minimum performance requirements by December 30, 2030, which is prior to the date the Federal Communications Commission authorizes the use of the Upper C-band for new wireless services, as stated in its Report and Order. All other aircraft equipped with radio altimeters that are required to comply with part 91, including aircraft operating under parts 125, 133, 135, 136, 137, 194, and all other aircraft operating under part 129 that are not subject to the initial deadline, must comply with the same minimum performance requirements on or before October 31, 2034.
2026-13440, Enabling Supersonic Overland Flight
The FAA wants to let supersonic planes fly over land again by updating old rules that banned them because of loud sonic booms. Thanks to new tech that keeps booms quiet, this change will open the door for faster, cooler flights across the U.S., helping America lead the world in supersonic travel. People and companies interested in supersonic flight should share their thoughts by August 17, 2026.
2026-13126, Designation-Restrict the Operation of Unmanned Aircraft in Close Proximity to a Fixed Site Facility; Extension of Comment Period
The FAA is giving more time—until August 5, 2026—for people to share their thoughts on new rules that would limit drone flights near important fixed sites like power plants or airports. This affects drone operators and facility owners who want to keep the skies safe and secure. No new costs yet, just extra time to weigh in and help shape the rules.
2026-08943, Designation-Restrict the Operation of Unmanned Aircraft in Close Proximity to a Fixed Site Facility
The FAA is proposing new rules to keep drones away from certain important fixed sites like power plants or airports to keep everyone safe and secure. If you own or operate one of these sites, you can request a drone flight restriction zone to protect your property and people nearby. Comments are open until July 6, 2026, and these changes could affect drone pilots and site operators, but no big costs are expected.
2025-04846, Extension of the Prohibition Against Certain Flights in the Territory and Airspace of Libya
The FAA is extending the ban on certain flights over Libya for three more years, until March 20, 2028. This affects U.S. airlines, commercial operators, and pilots with FAA certificates flying in Libyan airspace, due to ongoing safety risks. The rule also reminds everyone how to apply for special approvals or exemptions if needed.
2025-03853, Enforcement Policy Regarding “Drug and Alcohol Testing of Certificated Repair Station Employees Located Outside of the United States; Correction”
The FAA is giving repair stations outside the U.S. a break by delaying enforcement of new drug and alcohol testing rules until March 20, 2025. This means affected repair stations don’t have to worry about penalties if they aren’t fully following the updated rules just yet. The delay helps everyone get ready without rushing or extra costs.
Previous / Next Documents
Previous: 2026-23522, Protecting Consumers From SIM-Swap and Port-Out Fraud
Starting November 18, 2026, wireless providers must follow new rules to stop sneaky hackers from stealing your phone number through SIM-swap and port-out fraud. These rules make sure companies check your identity better before switching your number to a new device, protecting you from losing control of your calls and texts. Providers have until December 18, 2026, to fully comply, making your phone safer without costing you extra.
Next: 2026-23530, Automatic Enrollment Requirements Under Section 414A
Starting in 2028, certain retirement plans must automatically enroll employees in savings plans unless they opt out. This change, thanks to the SECURE 2.0 Act, helps more workers save for retirement by making saving the easy default. Employers and plan managers need to update their plans by January 19, 2027, to meet these new rules and keep the money flowing smoothly.