FAA Orders Airbus Helicopter Checks for Corroded Tail Rotor Blades
Published Date: 11/20/2026
Rule
Summary
If you own or operate certain Airbus Helicopters Deutschland EC135 models, listen up! Starting December 28, 2026, you’ll need to regularly check the tail rotor blade assembly for cracks caused by corrosion. If cracks show up, you must replace the part to keep flying safely. This rule helps prevent dangerous failures and keeps everyone safe in the skies—plus, it might cost some bucks for inspections and replacements.
Analyzed Economic Effects
5 provisions identified: 1 benefits, 4 costs, 0 mixed.
FAA cost estimates for compliance
The FAA estimates the AD affects 359 U.S.-registered helicopters. The estimated cost to inspect one affected TRB assembly is up to $305 (3 work-hours × $85/hr = $255 labor plus $50 parts), with a total cost to U.S. operators for one inspection cycle of up to $109,495; if a TRB assembly must be replaced, the FAA estimates on-condition cost per TRB assembly of $5,155 (3 work-hours × $85/hr + $4,900 parts) and up to $51,550 per helicopter if replacing up to 10 assemblies.
Mandatory tail-rotor inspections and replacements
If you own or operate Airbus Helicopters Deutschland (AHD) Model EC135P1, EC135P2, EC135P2+, EC135P3, EC135T1, EC135T2, EC135T2+, EC135T3, or EC635T2+ helicopters, you must repeatedly inspect certain tail rotor blade (TRB) assemblies for cracks beginning December 28, 2026. The FAA requires the repetitive inspections established in the incorporated EASA AD (including the 20-hour and 30-hour repetitive inspection intervals identified in the rulemaking discussion) and you must remove and replace any cracked TRB assembly; affected parts must be replaced before an affected part accumulates 1,432 hours time-in-service (TIS) since first installation, or within 10 hours TIS after the effective date, whichever occurs later.
Special flight permits are not allowed
Special flight permits under 14 CFR 21.197 and 21.199 are explicitly not allowed for helicopters subject to this AD. That means operators cannot use a special flight permit to fly an affected helicopter for maintenance or other purposes while noncompliant with this AD after December 28, 2026.
Prohibition on installing certain TRB assemblies
The AD prohibits installing a specified TRB assembly on any helicopter unless the installation meets the requirements set out in the incorporated EASA AD and the FAA AD's exceptions. Operators and maintenance organizations must confirm eligibility before installing the affected TRB assemblies.
Option to request Alternative Methods of Compliance (AMOCs)
Operators may request approval of an Alternative Method of Compliance (AMOC) from the Manager, International Validation Branch, FAA, following 14 CFR 39.19 procedures; requests go through your principal inspector or to AMOC@faa.gov, and you must notify your principal inspector before using any approved AMOC. The AD specifies the AMOC approval authority and contact procedures.
Personalized for You
How does this regulation affect your finances?
Personalize government policy and PRIA will tell you what this federal register document means for your household, plus every other regulation we track. PRIA reads each provision against your financial profile to show you exactly what matters to your wallet.
Key Dates
Department and Agencies
Related Federal Register Documents
2026-15585, Requirements for Interference-Tolerant Radio Altimeter Systems
In July 2025, President Trump signed the One Big Beautiful Bill Act. Section 40002 of that law re-institutes the Federal Communications Commission's general auction authority and specifically directs the Commission to complete a system of competitive bidding for not less than 100 megahertz in the 3.98-4.2 gigahertz band (Upper C- band). This final rule supports the Federal Communications Commission's July 2026 Report and Order that makes 160 megahertz of the Upper C-band available for terrestrial wireless flexible use via a system of competitive bidding. To ensure safe, efficient, and reliable aviation operations in the presence of wireless signals in the C-band, the Federal Aviation Administration is issuing new regulations that require all radio altimeters to meet specific minimum performance requirements. These new radio altimeters must withstand interference from wireless signals in neighboring spectrum bands and continue to provide accurate altitude readings to both pilots and integrated aircraft safety systems. These regulations require all aircraft equipped with radio altimeters operating under part 121 and those aircraft with radio altimeters operating under part 129 with 30 or more passenger seats or a payload capacity of more than 7,500 pounds to comply with the minimum performance requirements by December 30, 2030, which is prior to the date the Federal Communications Commission authorizes the use of the Upper C-band for new wireless services, as stated in its Report and Order. All other aircraft equipped with radio altimeters that are required to comply with part 91, including aircraft operating under parts 125, 133, 135, 136, 137, 194, and all other aircraft operating under part 129 that are not subject to the initial deadline, must comply with the same minimum performance requirements on or before October 31, 2034.
2026-13440, Enabling Supersonic Overland Flight
The FAA wants to let supersonic planes fly over land again by updating old rules that banned them because of loud sonic booms. Thanks to new tech that keeps booms quiet, this change will open the door for faster, cooler flights across the U.S., helping America lead the world in supersonic travel. People and companies interested in supersonic flight should share their thoughts by August 17, 2026.
2026-13126, Designation-Restrict the Operation of Unmanned Aircraft in Close Proximity to a Fixed Site Facility; Extension of Comment Period
The FAA is giving more time—until August 5, 2026—for people to share their thoughts on new rules that would limit drone flights near important fixed sites like power plants or airports. This affects drone operators and facility owners who want to keep the skies safe and secure. No new costs yet, just extra time to weigh in and help shape the rules.
2026-08943, Designation-Restrict the Operation of Unmanned Aircraft in Close Proximity to a Fixed Site Facility
The FAA is proposing new rules to keep drones away from certain important fixed sites like power plants or airports to keep everyone safe and secure. If you own or operate one of these sites, you can request a drone flight restriction zone to protect your property and people nearby. Comments are open until July 6, 2026, and these changes could affect drone pilots and site operators, but no big costs are expected.
2025-04846, Extension of the Prohibition Against Certain Flights in the Territory and Airspace of Libya
The FAA is extending the ban on certain flights over Libya for three more years, until March 20, 2028. This affects U.S. airlines, commercial operators, and pilots with FAA certificates flying in Libyan airspace, due to ongoing safety risks. The rule also reminds everyone how to apply for special approvals or exemptions if needed.
2025-03853, Enforcement Policy Regarding “Drug and Alcohol Testing of Certificated Repair Station Employees Located Outside of the United States; Correction”
The FAA is giving repair stations outside the U.S. a break by delaying enforcement of new drug and alcohol testing rules until March 20, 2025. This means affected repair stations don’t have to worry about penalties if they aren’t fully following the updated rules just yet. The delay helps everyone get ready without rushing or extra costs.
Previous / Next Documents
Previous: 2026-23676, Safety Zone; Annual Fireworks Display Within the Sector Columbia River Captain of the Port Zone, Richland, WA
On December 5, 2026, from 7 p.m. to 9:30 p.m., the Coast Guard will set up a safety zone around the Richland Lighted Boat Parade Fireworks to keep everyone safe on the water. Boats can’t enter this zone unless they get special permission, so plan ahead if you’re nearby. This temporary rule helps prevent accidents during the fireworks show and keeps the celebration fun and secure.
Next: 2026-23681, Reef Fish Fishery in the Gulf of America; 2026 Recreational Private Angling Component Closure for Red Snapper in Federal Waters off Texas
Starting November 21, 2026, private recreational anglers fishing for red snapper in federal waters off Texas will have to stop for the rest of the year. This temporary closure helps protect red snapper from being overfished and keeps the catch within safe limits. If you love fishing for red snapper near Texas, plan ahead and enjoy other spots or species!