FAA Inspects Cracked Helicopter Fork Levers for Safety
Published Date: 12/16/2025
Rule
Summary
If you own or fly certain Airbus Helicopters Deutschland models, listen up! The FAA found cracks in a key part called the fork lever and now requires inspections to catch damage or missing pieces. Starting December 31, 2025, you’ll need to check, fix, and report any issues to keep flying safe—and don’t install any suspect parts unless they meet new rules.
Analyzed Economic Effects
5 provisions identified: 0 benefits, 4 costs, 1 mixed.
Estimated per-helicopter compliance costs
The FAA estimates this AD affects 40 U.S.-registered helicopters and that the basic fork-lever inspection costs about 1 work-hour at $85, or $85 per helicopter. If repairs are needed, on-condition costs listed include replacing a fork lever at about $12,321, replacing a mixing lever assembly at about $22,188, and other repairs ranging from $510 to $1,014.
Mandatory fork lever inspections by Dec 31, 2025
If you own or operate the listed Airbus Helicopters Deutschland models, you must visually inspect the fork lever and mixing lever assembly no later than 30 days after December 31, 2025. If a visual inspection shows a line with no visible gap or misalignment, you must perform a borescope inspection before further flight. The rule applies to the specific models named in the AD and uses hours time-in-service for flight-hour compliance.
Installation and special flight permit restrictions
The AD prohibits installing affected fork levers unless certain requirements in the AD are met, and special flight permits are explicitly prohibited. That means operators cannot rely on a special flight permit to move an affected helicopter; compliance actions and any allowed installations must meet the AD conditions.
10‑day mandatory inspection reporting to Airbus
After performing the inspection required by this AD, you must report the inspection results directly to Airbus Helicopters within 10 days of accomplishing the inspection. The FAA estimates the reporting burden at about 1 work-hour (the Paperwork Reduction Act OMB Control Number is 2120-0056).
AD narrows inspection definitions and compliance rules
This FAA AD modifies EASA AD 2025-0217 in specific ways: it replaces certain EASA wording to define discrepancies (including missing locking devices, deformation, scratches, gouges, bearing play, or corrosion), requires using this AD's effective date, and requires using hours time-in-service where EASA used flight hours. These clarified definitions and substitutions must be followed for compliance.
Your PRIA Score
Personalized for You
How does this regulation affect your finances?
Sign up for a PRIA Policy Scan to see your personalized alignment score for this federal register document and every other regulation we track. We analyze your financial profile against policy provisions to show you exactly what matters to your wallet.
Key Dates
Department and Agencies
Related Federal Register Documents
2026-06506 — Airworthiness Directives; Bombardier Inc. Airplanes
The FAA is making a new rule for Bombardier airplanes to fix a problem where the nose wheel steering can act up during landing. Owners of certain Bombardier CL-600 models must replace specific screws in the nosewheel steering system and update their maintenance plans by May 8, 2026. This keeps flights safe and avoids costly repairs down the road.
2026-06563 — Airworthiness Directives; Airbus SAS Airplanes
The FAA wants Airbus A350-941 owners to fix a problem where some wing and belly parts weren’t tightened right during manufacturing. They’ll need to replace certain parts and add extra protection to keep the plane safe. Comments on this plan are open until May 18, 2026, and the fixes might cost some time and money but will keep flights safe and sound.
2026-06543 — Amendment of Class D and Class E2 Airspace Over Binghamton, NY
The FAA is shrinking the controlled airspace around Greater Binghamton Airport from a 4.4-mile radius to 4.3 miles. This change affects pilots flying near Binghamton, NY, making the airspace a bit tighter but still safe and efficient. The new rules kick in on July 9, 2026, with no extra costs for anyone.
2026-06492 — Airworthiness Directives; Airbus SAS Airplanes
The FAA wants all Airbus A350-941 and -1041 airplanes to replace certain flight control parts that might have been damaged during testing. This change keeps planes safe by banning the use of these risky parts. Airlines need to act before May 18, 2026, and while it might cost some money, it’s all about keeping flights smooth and secure.
2026-06527 — Airworthiness Directives; Honda Aircraft Company LLC Airplanes
If you own a Honda HA-420 airplane, listen up! The FAA says you need to replace your flap control pushrods with new, tougher ones that don’t need constant anti-rust treatments. This new rule kicks in on May 8, 2026, and helps keep your plane safe without extra hassle or cost from repeated maintenance.
2026-06534 — Airworthiness Directives; DG Aviation GmbH (Type Certificate Previously Held by DG Flugzeugbau GmbH) Gliders
If you own or maintain a DG-1000M glider, listen up! The FAA found cracks near the engine mount and is requiring inspections, maintenance updates, and new parts like a carbon fiber bracket to keep your glider safe. These changes kick in April 20, 2026, so get ready to inspect, adjust, and balance before then—safety first, and no surprise costs if you stay on top of it!
Previous / Next Documents
Previous: 2025-22841 — Modification and Revocation of Class E Airspace; Hawaiian Islands, HI; Correction
The FAA fixed some map details for the airspace around Kona Airport in Hawaii to make sure everything’s accurate. These changes affect pilots flying near the airport and take effect January 22, 2026. No extra costs or delays—just clearer skies and better navigation!
Next: 2025-22854 — Fisheries of the Exclusive Economic Zone Off Alaska; Reallocation of Pacific Cod in the Western Regulatory Area of the Gulf of Alaska
Starting December 15, 2025, some Pacific cod that catcher vessels using trawl gear won’t catch will be given to boats using hook-and-line and pot gear in the Western Gulf of Alaska. This switch helps make sure the total allowed catch for 2025 is fully used without wasting any fish. Fishermen using hook-and-line and pot gear get a chance to catch more Pacific cod before the year ends.
Take It Personal
Get Your Personalized Policy View
Start a Free Government Policy Watch to see how policy affects your household, then upgrade to PRIA Full Coverage for year-round monitoring.
Already have an account? Sign in