Part 219: ORGANIC MATERIAL EMISSION STANDARDS AND LIMITATIONS FOR THE METRO EAST AREA

Section 219.103 Applicability The provisions of this Part shall apply to all sources located in Madison, Monroe, and St. Clair Counties.

Section 219.104 Definitions The definitions of 35 Ill. Adm. Code 211 apply to this Part. (Source: Amended at 17 Ill. Reg. 16918, effective September 27, 1993)

Section 219.105 Test Methods and Procedures a) Coatings, Inks and Fountain Solutions The following test methods and procedures must be used to determine compliance of as applied coatings, inks, and fountain solutions with the limitations set forth in this Part. 1) Sampling: Sampl…

Section 219.106 Compliance Dates a) Except as provided in subsection (b), (c), (d), (e), or (f), compliance with the requirements of this Part is required by May 15, 1992, consistent with the provisions of Section 219.103. b) As this Part is amended from time to time, compliance …

Section 219.107 Operation of Afterburners The operation of any natural gas fired afterburner and capture system used to comply with this Part is not required during the period of November 1 of any year to April 1 of the following year provided that the operation of such devices i…

Section 219.108 Exemptions, Variations, and Alternative Means of Control or Compliance Determinations Notwithstanding the provisions of any other Sections of this Part: a) Any exemptions, variations or alternatives to the control requirements, emission limitations, or test method…

Section 219.109 Vapor Pressure of Volatile Organic Liquids a) If the VOL consists of only a single compound, the vapor pressure shall be determined by ASTM Method D2879-86 (incorporated by reference in Section 219.112 of this Part) or the vapor pressure may be obtained from a pub…

Section 219.110 Vapor Pressure of Organic Material or Solvent a) If the organic material or solvent consists of only a single compound, the vapor pressure must be determined by ASTM Method D2879-86 (incorporated by reference in Section 219.112 of this Part) or the vapor pressure …

Section 219.111 Vapor Pressure of Volatile Organic Material a) If the VOM consists of only a single compound, the vapor pressure shall be determined by ASTM Method D2879-86 (incorporated by reference in Section 219.112 of this Part) or the vapor pressure may be obtained from a pu…

Section 219.112 Incorporations by Reference The following materials are incorporated by reference and do not contain any subsequent additions or amendments: a) American Society for Testing and Materials, 100 Barr Harbor Drive, West Conshohocken PA 19428-9555 1) ASTM D 2879-86 2) …

Section 219.113 Monitoring for Negligibly-Reactive Compounds The requirements of 35 Ill. Adm. Code 215.109, which allows the Agency to require testing and monitoring for negligibly-reactive compound as a precondition to their exemption from the definition of "volatile organic com…

Section 219.119 Applicability for VOL The limitations of Section 219.120 of this Subpart shall apply to all storage containers of volatile organic liquid (VOL) with a maximum true vapor pressure of 0.5 psia or greater in any stationary tank, reservoir, or other container of 151 c…

Section 219.120 Control Requirements for Storage Containers of VOL a) Every owner or operator storing VOL in a vessel of 40,000 gallons or greater with a maximum true vapor pressure equal to 0.75 psia but less than 11.1 psia shall reduce VOM emissions from storage tanks, reservoi…

Section 219.121 Storage Containers of VPL No person shall cause or allow the storage of any volatile petroleum liquid (VPL) with a vapor pressure of 10.34 kPa (1.5 psia) or greater at 294.3° K (70°F) or any gaseous organic material in any stationary tank, reservoir or other conta…

Section 219.122 Loading Operations a) No person shall cause or allow the discharge of more than 3.6 kg/hr (8lbs/hr) of organic material into the atmosphere during the loading of any organic material from the aggregate loading pipes of any loading area having through-put of greate…

Section 219.123 Petroleum Liquid Storage Tanks a) The requirements of subsection (b) of this Section shall not apply to any stationary storage tank: 1) Equipped before January 1, 1979 with one of the vapor loss control devices specified in Section 219.121(b) of this Part, except …

Section 219.124 External Floating Roofs a) In addition to meeting the requirements of Section 219.123(b) of this Part, no owner or operator of a stationary storage tank equipped with an external floating roof shall cause or allow the storage of any volatile petroleum liquid in th…

Section 219.125 Compliance Dates Every owner or operator of a VOL or VPL storage vessel subject to the requirements of this Subpart shall comply with the requirements of this Subpart in accordance with the compliance schedule specified in the applicable subsection below: a) Every…

Section 219.126 Compliance Plan (Repealed) (Source: Repealed at 17 Ill. Reg. 16918, effective September 27, 1993)

Section 219.127 Testing VOL Operations The owner or operator of each storage vessel specified in Section 219.119 of this Subpart shall comply with the requirements of subsection (a), (b), or (c) below. The applicable subsection for a particular storage vessel depends on the contr…

Section 219.128 Monitoring VOL Operations a) Except as provided in subsection (d), the owner or operator of each storage vessel with a design capacity greater than or equal to 40,000 gallons storing a liquid with a maximum true vapor pressure that is normally less than 0.75 psia …

Section 219.129 Recordkeeping and Reporting for VOL Operations The owner or operator of each storage vessel specified in Section 219.120(a) of this Subpart shall maintain records and furnish reports as required by subsection (a), (b), or (c) below as appropriate for the control e…

Section 219.141 Separation Operations a) No person shall use any single or multiple compartment effluent water separator which receives effluent water containing 757 1/day (200 gal/day) or more of organic material from any equipment processing, refining, treating, storing or hand…

Section 219.142 Pumps and Compressors No person shall cause or allow the discharge of more than 32.8 ml (2 cu in) of VOL with vapor pressure of 17.24 kPa (2.5 psia) or greater at 294.3°K (70°F) into the atmosphere from any pump or compressor in any 15 minute period at standard co…

Section 219.143 of this Part shall not apply to any set of unregulated safety relief valves capable of causing excessive releases, provided the owner or operator thereof, by October 1, 1972, supplied the Agency with the following: a) A historical record of each such set (or, if s…

Section 219.144 Safety Relief Valves SUBPART E: SOLVENT CLEANING

Section 219.181 Solvent Cleaning Degreasing Operations The requirements of Sections 219.182, 219.183, 219.184, and 219.186 of this Subpart shall apply to all cold cleaning, open top vapor degreasing, and conveyorized degreasing operations which use volatile organic materials. (So…

Section 219.182 Cold Cleaning a) Operating Procedures: No person shall operate a cold cleaning degreaser unless: 1) Waste solvent is stored in covered containers only and not disposed of in such a manner that more than 20% of the waste solvent (by weight) is allowed to evaporate …

Section 219.183 Open Top Vapor Degreasing a) Operating Requirements: No person shall operate an open top vapor degreaser unless: 1) the cover of the degreaser is closed when workloads are not being processed through the degreaser; 2) solvent carryout emissions are minimized by: A…

Section 219.184 Conveyorized Degreasing a) Operating Requirements: No person shall operate a conveyorized degreaser unless: 1) Exhaust ventilation exceeding 20 cubic meters per minute per square meter (65 cubic feet per minute per square foot) of area of loading and unloading ope…

Section 219.185 Compliance Schedule (Repealed) (Source: Repealed at 17 Ill. Reg. 16918, effective September 27, 1993)

Section 219.186 Test Methods The following test methods shall be used to demonstrate compliance with this Subpart: a) Vapor pressures shall be determined by using the procedure specified in Section 219.110 of this Part. b) Exhaust ventilation rates shall be determined by using th…

Section 219.187 Other Industrial Solvent Cleaning Operations a) Applicability. On and after January 1, 2012: 1) Except as provided in subsection (a)(2), the requirements of this Section apply to all cleaning operations that use organic materials at sources that emit a total of 22…

Section 219.204 Emission Limitations Except as provided in Sections 219.205, 219.207, 219.208, 219.212, 219.215 and 219.216, an owner or operator of a coating line must not apply at any time any coating in which the VOM content exceeds the following emission limitations for the s…

Section 219.205 Daily-Weighted Average Limitations An owner or operator of a coating line subject to the limitations of Section 219.204 and complying by means of this Section must not operate the subject coating line unless the owner or operator has demonstrated compliance with s…

Section 219.206 Solids Basis Calculation Limitations in terms of kg (lbs) of VOM emissions per 1 (gal) of solids as applied at each coating applicator shall be determined by the following equation: where: S = The limitation on VOM emissions in terms of kg VOM/l (lbs VOM/gal) of s…

Section 219.207 Alternative Emission Limitations a) Any owner or operator of a coating line subject to Section 219.204, except coating lines subject to Section 219.204(q)(6), may comply with this Section, rather than with Section 219.204, if a capture system and control device ar…

Section 219.208 Exemptions From Emission Limitations a) Exemptions for all coating categories except wood furniture coating and aerospace facilities. The limitations of this Subpart do not apply to coating lines within a source, that otherwise would be subject to the same subsect…

Section 219.209 Exemption From General Rule on Use of Organic Material No owner or operator of a coating line subject to the limitations of Section 219.204 of this Part is required to meet the limitations of Subpart G (Section 219.301 or 219.302) of this Part, after the date by w…

Section 219.210 Compliance Schedule Every owner or operator of a coating line (of a type included within Section 219.204 of this Subpart) shall comply with the requirements of Section 219.204, 219.205, 219.207 or 219.208 and Section 219.211 or Sections 219.212 and 219.213 of this…

Section 219.211 Recordkeeping and Reporting a) The VOM content of each coating and the efficiency of each capture system and control device must be determined by the applicable test methods and procedures specified in Section 219.105 to establish the records required under this S…

Section 219.212 Cross-Line Averaging to Establish Compliance for Coating Lines a) On and after March 15, 1996, any owner or operator of a coating line subject to the limitations set forth in Section 219.204 of this Subpart, except coating lines subject to the limitations in Secti…

Section 219.213 Recordkeeping and Reporting for Cross-Line Averaging Participating Coating Lines Any owner or operator of a coating line that elects to comply by means of Section 219.212 of this Subpart shall establish the following: a) By the date consistent with Section 219.210…

Section 219.214 Changing Compliance Methods a) At least 30 calendar days before changing the method of compliance with this Subpart from Section 219.212 of this Subpart to Section 219.204 or Section 219.207 of this Subpart, the owner or operator of a source relying on Section 219…

Section 219.215 Wood Furniture Coating Averaging Approach a) On and after March 15, 1998, any owner or operator of a source subject to the limitations of Section 219.204(l) of this Subpart may elect to comply with the requirements of this Section rather than complying with the ap…

Section 219.216 Wood Furniture Coating Add-On Control Use The owner or operator of a source subject to the requirements of Section 219.204(l)(2) of this Subpart may choose to comply with those limitations by relying on Section 219.204(l)(2)(D) of this Subpart if the owner or oper…

Section 219.217 Wood Furniture Coating and Flat Wood Paneling Coating Work Practice Standards a) Spray booth cleaning. Each owner or operator of a source subject to the limitations of Section 219.204(l) of this Subpart shall not use compounds containing more than 8.0 percent, by …