Washington Administrative Code

(1) You must make sure condensers are designed:(a) For at least 250 psig; and(b) To manually or automatically purge noncondensibles.Note:Condensers may be cooled by any of the following: 1. Air; 2. Water; 3. Air and water.(2) You must make sure compressors used for refrigerating …

Your responsibility:To follow the requirements in this section when using appurtenances.You must meet the requirements …in this section:Appurtenance requirements for all systemsWAC 296-826-50005Nonrefrigerated stationary containersWAC 296-826-50010Refrigerated tanksWAC 296-826-50…

(1) You must make sure each appurtenance installed before February 8, 1973, is determined to be safe by meeting one of the following:(a) Approved, tested, and installed by either:(i) The American National Standard for the Storage and Handling of Anhydrous Ammonia (in effect at th…

Important:In addition to this section, you need to follow the Appurtenances requirements for all systems, WAC 296-826-50005.(1) You must make sure all containers are equipped with all of the following:(a) An approved vapor return valve;(b) A fixed maximum liquid level gauge;(c) A…

Important:In addition to this section, you need to follow the Appurtenances requirements for all systems, WAC 296-826-50005.(1) You must protect container appurtenances against the following:(a) Physical damage during transit of containers intended for underground installation;(b…

Important:In addition to this section, you need to follow the Appurtenances requirements for all systems, WAC 296-826-50005.(1) You must make sure each container has all of the following:(a) Fixed maximum liquid level gauging devices;(b) Pressure-indicator gauges with a dial grad…

Important:This section applies to containers of three thousand gallons capacity or less and pertinent equipment mounted on farm trucks or trailers used for the transportation of ammonia.In addition to this section, you need to follow the Appurtenances requirements for all systems…

Important:This section applies to systems mounted on farm equipment and used for the filed application of ammonia.In addition to this section, you need to follow the Appurtenances requirements for all systems, WAC 296-826-50005.(1) You must make sure each container has a fixed ma…

Important:This section applies to systems that use cylinders, portable tanks (DOT-51), or ton containers (DOT-106A, DOT-110A).In addition to this section, you need to follow the Appurtenances requirements for all systems, WAC 296-826-50005.(1) You must make sure safety relief dev…

SummaryYour responsibility:To protect employees while transporting, transferring, loading and unloading anhydrous ammonia.Requirements for this topic …begin in this section:Mounting and loading containersWAC 296-826-60005Transferring liquidsWAC 296-826-60020Filling densitiesWAC 2…

(1) You must make sure the method for attaching any container to the cradle, frame, or chassis of a vehicle is based on both of the following:(a) Two "g" loading in either direction;(b) Using a safety factor of at least four based on the maximum strength of the material used.Note…

(1) You must make sure tanks mounted on farm trucks and trailers meet all of the following:(a) Are securely attached using drawbars and safety chains;(b) Follow behind the towing vehicle without swerving;(c) Have at least five gallons of readily available clean water.(2) You must…

(1) You must establish a location for tank car loading and unloading operations. (2) You must assign employees and instruct them in the unloading of tank cars. (3) You must make sure, when unloading cars, to set the brake and block the wheels. (4) You must make sure the track of …

You must meet the requirements ...in this section:General specificationsWAC 296-826-60020Additional requirements for systems mounted on trucks, semi-trailers, and trailers for transporting ammoniaWAC 296-826-60025(1) You must get owner authorization to use transfer containers. (2…

(1) You must make sure the content of vehicle containers is determined by one of the following:(a) Weight;(b) Liquid-level gauging devices;(c) Meters; or(d) Other approved methods.(2) You must use a thermometer well when the content of a container is determined by liquid-level me…

You must meet the requirements …in this section:Nonrefrigerated containersWAC 296-826-60030Refrigerated tanksWAC 296-826-60035WeldingWAC 296-826-60040You must make sure filling densities for nonrefrigerated containers are below or equal to the requirements in Table 15, Filling De…

You must make sure refrigerated tanks are not liquid full at a liquid temperature so that the vapor pressure is below the "start-to-discharge" pressure setting of the safety relief valve.[Statutory Authority: RCW 49.17.010, 49.17.040, 49.17.050. WSR 15-23-086, § 296-826-60035, fi…

You must permit welding only on the saddle plates, lugs, or brackets attached to the container by the manufacturer.[Statutory Authority: RCW 49.17.010, 49.17.040, 49.17.050. WSR 15-23-086, § 296-826-60040, filed 11/17/15, effective 12/18/15. Statutory Authority: RCW 49.17.010, 49…

Action level. An airborne concentration of a hazardous substance that is calculated as an 8-hour time-weighted average, and initiates certain requirements to be followed such as exposure monitoring or medical surveillance.Carcinogens. See "Select carcinogen."Chemical hygiene offi…

This chapter applies to the laboratory use of hazardous chemicals. To determine if this chapter applies to your workplace, use Table 1.Important:1. When your laboratory operation is covered by this chapter, and you use any of the substances in Table 2, the following applies with …

SummaryYour responsibility:To protect employees from laboratory use of hazardous chemicals.You must meet the requirements…in this section:Chemical hygiene planWAC 296-828-20005Exposure evaluationWAC 296-828-20010TrainingWAC 296-828-20015Labeling and safety data sheets (SDSs)WAC 2…

(1) You must develop and carry out a written chemical hygiene plan (CHP) that will protect your employees from hazardous substances in the laboratory and keep exposure levels below those listed in chapter 296-841 WAC, Airborne contaminants.(2) You must make sure the written plan …

Important:For any of the specific substances listed in Table 2 of the scope of this chapter, you need to follow the exposure evaluation procedures found in the chapters regulating those substances if employee exposure routinely exceeds the AL or PEL. For all other employee exposu…

(1) You must inform employees about the presence of hazardous chemicals at the following times:(a) At the time of initial assignment to a work area where hazardous chemicals are present.(b) Prior to situations involving a new exposure to hazardous chemicals.(2) You must train emp…

(1) You must make sure labels on incoming containers are not removed or defaced.(2) You must keep and make available to employees any SDS received with an incoming container of hazardous chemicals.[Statutory Authority: RCW 49.17.010, 49.17.040, 49.17.050, 49.17.060. WSR 15-24-102…

You must follow Table 3 for chemical substances produced in your laboratory.Table 3Lab Produced Chemical Substance RequirementsIfThenThe chemical is a hazardous chemicalFollow all appropriate requirements of this chapterA chemical by-product is produced and its composition is unk…

Important:For any of the specific substances listed in Table 2 of the scope of this chapter, you need to follow the medical evaluation procedures found in the chapters regulating those substances if employee exposure routinely exceeds the AL or PEL. For all other employee exposur…

Aviation gasoline. Gasoline fuel for reciprocating piston engine helicopters, also known as avgas.Cargo hook. A device attached to a helicopter that is used to hold suspended loads.Competent person. One who is capable of identifying existing and predictable hazards in the surroun…

Chapter 296-829 WAC applies to helicopters when used to carry loads, suspended with a cargo sling, powered hoist, or other attaching methods.EXEMPTION:This chapter does not apply to the use of helicopters: 1. In the logging industry. 2. For rescue operations when a winch or hoist…

Summary:Your responsibility: To make sure your helicopters meet design specifications and are equipped properly.You must meet the requirements...in this section:Follow Federal Aviation Administration (FAA) requirementsWAC 296-829-20005Install and test hooks on helicopters correct…

You must make sure helicopter cranes and their use meet the applicable requirements of the Federal Aviation Administration (FAA).[Statutory Authority: RCW 49.17.010, 49.17.040, 49.17.050, 49.17.060, and chapter 49.17 RCW. WSR 14-09-095, § 296-829-20005, filed 4/22/14, effective 7…

(1) You must make sure electrically operated cargo hooks are:(a) Designed and installed to prevent accidental operation.(b) Equipped with an emergency mechanical control to release the load.(2) You must make sure a competent person tests all hooks before each day's operation to m…

Summary:Your responsibility: To keep helicopters in safe operating condition.You must meet the requirements...in this section:Keep landing and deposit areas safeWAC 296-829-30005Follow safe refueling proceduresWAC 296-829-30010[Statutory Authority: RCW 49.17.010, 49.17.040, 49.17…

(1) You must make sure precautions are taken to prevent loose objects from being caught in the downwash and flying around. Secure or remove all loose gear:(a) Within one hundred feet of lift and deposit areas.(b) In all other areas affected by rotor downwash.(2) You must make sur…

(1) You must make sure refueling areas are safe.(a) Post "NO SMOKING" signs at all entrances to the refueling area.(b) Provide at least one thirty-pound fire extinguisher, or a combination totaling thirty pounds, good for class A, B, and C fires, within one hundred feet on the up…

Summary:Your responsibility: To make sure helicopters are operated safely.You must meet the requirements...in this section:Hold daily briefingsWAC 296-829-40005Make sure employees are dressed correctlyWAC 296-829-40010Make sure loads are attached correctlyWAC 296-829-40015Make su…

You must make sure the helicopter pilot and ground personnel hold a briefing before each day's operation to discuss cargo-handling plans.[Statutory Authority: RCW 49.17.010, 49.17.040, 49.17.050, 49.17.060, and chapter 49.17 RCW. WSR 14-09-095, § 296-829-40005, filed 4/22/14, eff…

You must make sure employees receiving the load:(1) Do not wear loose-fitting clothes that could snag on the hoist line.(2) Wear personal protective equipment (PPE), including complete eye protection and hard hats that are secured by chin straps.Reference:For other requirements r…

(1) You must make sure loads are properly slung so tag lines cannot be drawn up into rotors.(2) You must make sure precautions are taken on all freely suspended loads to keep hand splices from spinning open or cable clamps from loosening, such as using pressed sleeves or swedged …

(1) You must make sure signal systems, whether radio or hand signals, are checked before hoisting the load. When using hand signals, use those shown in Illustration 1.(2) You must make sure workers on the ground do either of the following before touching the suspended load:(a) Us…

This chapter applies to all adult entertainment establishments.In addition to this chapter, chapter 296-800 WAC Safety and health core rules, chapter 296-24 WAC General safety and health standards, and chapter 296-62 WAC General occupational health standards contain safety and he…

The definitions below exclusively apply to this chapter.(1) Adult entertainment. Any exhibition, performance, or dance of any type conducted within the view of one or more members of the public inside a premises where such exhibition, performance, or dance involves an entertainer…

(1) Adult entertainment establishments must have a written accident prevention program (APP) that addresses requirements in WAC 296-800-140 through 296-800-14025. An establishment's APP must cover the following (in addition to other general safety and health considerations applic…

(1) Adult entertainment establishments must provide an accessible panic button in each room in the establishment in which an entertainer may be alone with a customer, and in bathrooms and dressing rooms. An entertainer may use the panic button if the entertainer has been harmed, …

(1) Adult entertainment establishments must make sure that an alarm system, with a distinctive (not confused with fire alarm, etc.) signal, is installed for the purposes of communicating entertainer violence related emergencies to employer-designated responders.(2) Establishments…

(1) Adult entertainment establishments must train entertainers on the following, prior to their work as entertainers.(a) The location and type of panic buttons used in the establishment (audible/discreet at the point of use).(b) How to use panic button(s).(c) Proper scenarios for…

(1) An adult entertainment establishment must provide at least one dedicated security person on the premises during operating hours whose primary duty is security, including monitoring interactions between entertainers and customers.(2) During peak operating hours, security perso…

(1) Adult entertainment establishments must record in a customer complaint log the allegations it receives that a customer has committed sex trafficking, prostitution, promotion of prostitution, or an act of violence, including assault, sexual assault, or sexual harassment, towar…

This rule applies to all retail businesses operating between the hours of 11:00 p.m. and 6:00 a.m.Exemption:This chapter does not apply to restaurants, hotels, taverns, and lodging facilities.[Statutory Authority: RCW 49.17.010, [49.17].040, [49.17].050, and [49.17].060. WSR 02-1…

summaryYour responsibility: To make sure all employees receive crime prevention training as part of your accident prevention program.You must meet the requirements…in this section:Provide crime prevention training to your employeesWAC 296-832-20005Provide crime prevention retrain…