Airbus Landing Gear Door Inspections Get Another Federal Tune-Up
Published Date: 7/8/2025
Proposed Rule
Summary
The FAA is updating safety rules for many Airbus A318 to A321 airplanes to keep them flying safely. They want airlines to keep inspecting the main landing gear doors and now also replace any faulty parts to prevent problems. Comments are open until August 22, 2025, and these changes might cost some money but will keep passengers safe and planes in top shape.
Analyzed Economic Effects
5 provisions identified: 1 benefits, 4 costs, 0 mixed.
Mandatory MLG door replacement within 12 months
If an affected MLG door has not already been replaced because of inspections, you must replace each affected MLG door with a serviceable part within 12 months. The FAA proposes this addition to the existing AD to address incorrectly assembled MLG door actuators.
Reduces risk of landing gear failure and fire
This proposed AD targets jamming or inability to open MLG doors caused by incorrectly assembled actuators, which could prevent landing gear extension and possibly cause significant airplane damage or a fire requiring emergency evacuation. The AD adds replacement requirements to address that unsafe condition.
FAA cost estimates for U.S. operators
The FAA estimates the proposed AD would affect 1,933 U.S.-registered airplanes. Estimated costs include $170 per inspection (2 work-hours × $85/hour) totaling $328,610 per inspection cycle across the U.S. fleet; replacement cost per airplane is estimated at $9,579 (3 work-hours × $85/hour = $255 plus $9,324 parts), totaling $18,516,207 if all require replacement. An on-condition replacement estimate is $9,919 per airplane (7 work-hours × $85 = $595 plus $9,324 parts).
Keep inspecting main landing gear doors
If you operate Airbus A318–A321 family airplanes in the U.S., you must continue the repetitive inspections of the main landing gear (MLG) doors required by AD 2024-25-06 and EASA AD 2024-0216. The rule applies to 1,933 U.S.-registered airplanes identified in the proposed AD.
Installation of affected MLG parts prohibited
The proposed AD incorporates EASA AD 2024-0216, which prohibits the installation of affected MLG actuators/parts; operators may not install parts identified as affected in the referenced EASA AD. This prohibition is part of the compliance requirements.
Personalized for You
How does this regulation affect your finances?
Personalize government policy and PRIA will tell you what this federal register document means for your household, plus every other regulation we track. PRIA reads each provision against your financial profile to show you exactly what matters to your wallet.
Key Dates
Department and Agencies
Related Federal Register Documents
2026-15585, Requirements for Interference-Tolerant Radio Altimeter Systems
In July 2025, President Trump signed the One Big Beautiful Bill Act. Section 40002 of that law re-institutes the Federal Communications Commission's general auction authority and specifically directs the Commission to complete a system of competitive bidding for not less than 100 megahertz in the 3.98-4.2 gigahertz band (Upper C- band). This final rule supports the Federal Communications Commission's July 2026 Report and Order that makes 160 megahertz of the Upper C-band available for terrestrial wireless flexible use via a system of competitive bidding. To ensure safe, efficient, and reliable aviation operations in the presence of wireless signals in the C-band, the Federal Aviation Administration is issuing new regulations that require all radio altimeters to meet specific minimum performance requirements. These new radio altimeters must withstand interference from wireless signals in neighboring spectrum bands and continue to provide accurate altitude readings to both pilots and integrated aircraft safety systems. These regulations require all aircraft equipped with radio altimeters operating under part 121 and those aircraft with radio altimeters operating under part 129 with 30 or more passenger seats or a payload capacity of more than 7,500 pounds to comply with the minimum performance requirements by December 30, 2030, which is prior to the date the Federal Communications Commission authorizes the use of the Upper C-band for new wireless services, as stated in its Report and Order. All other aircraft equipped with radio altimeters that are required to comply with part 91, including aircraft operating under parts 125, 133, 135, 136, 137, 194, and all other aircraft operating under part 129 that are not subject to the initial deadline, must comply with the same minimum performance requirements on or before October 31, 2034.
2026-13440, Enabling Supersonic Overland Flight
The FAA wants to let supersonic planes fly over land again by updating old rules that banned them because of loud sonic booms. Thanks to new tech that keeps booms quiet, this change will open the door for faster, cooler flights across the U.S., helping America lead the world in supersonic travel. People and companies interested in supersonic flight should share their thoughts by August 17, 2026.
2026-13126, Designation-Restrict the Operation of Unmanned Aircraft in Close Proximity to a Fixed Site Facility; Extension of Comment Period
The FAA is giving more time—until August 5, 2026—for people to share their thoughts on new rules that would limit drone flights near important fixed sites like power plants or airports. This affects drone operators and facility owners who want to keep the skies safe and secure. No new costs yet, just extra time to weigh in and help shape the rules.
2026-08943, Designation-Restrict the Operation of Unmanned Aircraft in Close Proximity to a Fixed Site Facility
The FAA is proposing new rules to keep drones away from certain important fixed sites like power plants or airports to keep everyone safe and secure. If you own or operate one of these sites, you can request a drone flight restriction zone to protect your property and people nearby. Comments are open until July 6, 2026, and these changes could affect drone pilots and site operators, but no big costs are expected.
2025-04846, Extension of the Prohibition Against Certain Flights in the Territory and Airspace of Libya
The FAA is extending the ban on certain flights over Libya for three more years, until March 20, 2028. This affects U.S. airlines, commercial operators, and pilots with FAA certificates flying in Libyan airspace, due to ongoing safety risks. The rule also reminds everyone how to apply for special approvals or exemptions if needed.
2025-03853, Enforcement Policy Regarding “Drug and Alcohol Testing of Certificated Repair Station Employees Located Outside of the United States; Correction”
The FAA is giving repair stations outside the U.S. a break by delaying enforcement of new drug and alcohol testing rules until March 20, 2025. This means affected repair stations don’t have to worry about penalties if they aren’t fully following the updated rules just yet. The delay helps everyone get ready without rushing or extra costs.
Previous / Next Documents
Previous: 2025-12638, Implementation of the Administrative False Claims Act
The Federal Labor Relations Authority is setting up clear rules to handle false claims under the new Administrative False Claims Act. This affects anyone dealing with government claims, making sure false statements get caught and dealt with fairly. Comments on these rules are open until September 8, 2025, so get involved and help shape the process!
Next: 2025-12671, Airworthiness Directives; The Boeing Company Airplanes
The FAA wants to make sure Boeing 757-200 planes are super safe by checking if their main landing gear outer cylinders were damaged during manufacturing. If any are found, they’ll need to be replaced to avoid problems. Airlines must review records or inspect parts soon, with comments on this plan due by August 22, 2025, so no surprises or big costs sneak up later!