Mine Seeks Permission for Testing Gear in Restricted Air Areas
Published Date: 11/17/2026
Notice
Summary
Crimson Oak Grove Resources wants to change a safety rule at their Oak Grove Mine in Alabama. They’re asking to use special electronic testing gear that’s usually not allowed in certain air areas of the mine, promising it’s just as safe. If approved, this could speed up work without costing extra, but everyone has until December 17, 2026, to share their thoughts.
Analyzed Economic Effects
4 provisions identified: 3 benefits, 1 costs, 0 mixed.
Request to Use Specific Non‑Permissible Testing Gear
Crimson Oak Grove Resources asked MSHA (Docket M-2026-026-C) to allow specific non-permissible, low-voltage or battery-powered electronic testing and diagnostic equipment in the return air outby the last open crosscut at the Oak Grove Mine. The allowed list includes AMS 2140 Machinery Health Analyzer, laptop computers, oscilloscopes, insulation testers (meggers), signal analyzers, ultrasonic measuring devices, electronic component testers, and electronic tachometers (fault detectors are not allowed).
Strict Methane and Usage Limits for Equipment
The petition requires that the listed equipment must not be used if methane is detected at or above 1.0 percent; equipment must be de-energized immediately and withdrawn to fresh air if 1.0 percent methane is detected. Methane tests must be made at least 12 inches from the roof, face, ribs and floor before energizing equipment, and a qualified person must continuously monitor methane immediately before and during use.
Lithium Battery and Equipment‑Age Safety Rules
Equipment containing lithium batteries must meet UL1642 or IEC 62133; batteries must not be charged underground, replacement batteries shall not be brought into the subject area, and batteries must be changed out in intake air. Battery packs must not be disassembled, must be charged only with the original manufacturer's charger on the surface, must not be exposed to water or heat, and must be removed when performance decreases by greater than 20 percent. Equipment used must be no older than 10 years from date of manufacture or removed at manufacturer's end of service life.
Recordkeeping, Inspection, Training, and EMI/RFI Testing Conditions
The petition requires pre-use MSHA inspection, weekly examinations recorded in equipment records (entries may be expunged after one year), servicing per manufacturer recommendations with service dates recorded, RFI/EMI testing (with records like NIOSH tests) and MSHA notification at least 5 working days before such testing. All users must be qualified and trained on the PDO terms before using equipment; the PDO must be posted on mine bulletin boards for at least 60 consecutive days. Records and manuals must be maintained on mine property and made available to Authorized Representatives and miners.
Personalized for You
How does this regulation affect your finances?
Personalize government policy and PRIA will tell you what this federal register document means for your household, plus every other regulation we track. PRIA reads each provision against your financial profile to show you exactly what matters to your wallet.
Key Dates
Department and Agencies
Related Federal Register Documents
2026-15670, Roof Control Plan Approval Criteria
In response to a public request, the Mine Safety and Health Administration (MSHA) is reopening the rulemaking record and is scheduling a virtual public hearing on the Agency's proposed rule published on July 1, 2025, titled, "Roof Control Plan Approval Criteria."
2026-15717, Ventilation Plan Approval Criteria
In response to a public request, the Mine Safety and Health Administration (MSHA) is reopening the rulemaking record and is scheduling a virtual public hearing on the Agency's proposed rule published on July 1, 2025, titled, "Ventilation Plan Approval Criteria."
2026-10456, Department of Labor Federal Civil Penalties Inflation Adjustment Act Annual Adjustments for 2026
Good news for businesses and workers: the Department of Labor won’t raise any fines or penalties in 2026 because the usual inflation data wasn’t available. This means all civil penalties stay the same starting May 27, 2026. So, no surprise cost hikes this year—just steady rules and steady fees!
2025-12232, Ventilation Plan Approval Criteria
The Mine Safety and Health Administration (MSHA) wants to change how mine ventilation plans get approved. They’re removing the power of District Managers to add extra rules, making the process clearer and fairer. Mine operators should get ready to comment by July 31, 2025, but no big costs or delays are expected.
2026-23312, Proposed Extension of Information Collection: Proximity Detection Systems for Continuous Mining Machines in Underground Coal Mines
The Mine Safety and Health Administration wants to keep collecting info on safety systems that help prevent accidents with mining machines underground. This affects coal mine operators who use these machines and helps keep miners safe without adding extra paperwork hassle. Comments on this plan are open until January 19, 2027, so speak up if you have thoughts!
2026-23390, Respirable Crystalline Silica and Respiratory Protection
This update fixes a small mistake in the rules about protecting miners from harmful silica dust. It affects underground and surface coal mine operators by clarifying exposure limits to dangerous dust and gases. The correction takes effect November 17, 2026, helping keep miners safer without adding big costs.
Previous / Next Documents
Previous: 2026-23307, Petition for Modification of Application of Existing Mandatory Safety Standards
Ramaco Resources wants to change a safety rule about how air moves in their Tiller No. 1 mine in Virginia. They’re asking to let return air flow through a new path to the surface, promising it’s just as safe as current rules. Everyone can share their thoughts by December 17, 2026, and this could affect how ventilation works without extra costs.
Next: 2026-23309, Petition for Modification of Application of Existing Mandatory Safety Standards
Coeur Alaska Inc. wants to change a safety rule at their Kensington Mine in Alaska. They’re asking to use new blasting methods that don’t need a 15-foot air gap between power and blasting lines but still keep miners safe. Comments on this change must be sent by December 17, 2026, so everyone has time to weigh in before any money or safety impacts happen.