Illinois Administrative Code

Section 218.920 Applicability a) Maximum theoretical emissions: 1) A source is subject to this Subpart if it contains process emission units not regulated by Subparts B, E, F (excluding Section 218.204(l)), H (excluding Section 218.405), Q, R, S, T, (excluding Section 218.486) V,…

Section 218.923 Permit Conditions (Repealed) (Source: Repealed at 18 Ill. Reg. 1945, effective January 24, 1994)

Section 218.926 Control Requirements Every owner or operator of miscellaneous fabricated product manufacturing process emission unit subject to this Subpart shall comply with the requirements of subsection (a), (b) or (c) of this Section: a) Emission capture and control technique…

Section 218.927 Compliance Schedule Every owner or operator of an emission unit subject to the control requirements of this Subpart shall comply with the requirements thereof on and after a date consistent with Section 218.106 of this Part. (Source: Amended at 17 Ill. Reg. 16636,…

Section 218.928 Testing a) When in the opinion of the Agency it is necessary to conduct testing to demonstrate compliance with Section 218.926, the owner or operator of a VOM emission unit subject to the requirements of this Subpart shall, at his own expense, conduct such tests i…

Section 218.929 Cementable and Dress or Performance Shoe Leather a) The rule requirements of this Section apply to a leather manufacturing facility at 2015 North Elston Avenue, Chicago, Illinois. The VOM emission limits set forth in this Section shall only apply to the following …

Section 218.940 Applicability a) Maximum theoretical emissions: 1) A source is subject to this Subpart if it contains process emission units not regulated by Subparts B, E, F (excluding Section 218.204(l)), H (excluding Section 218.405), Q, R, S, T (excluding Section 218.486), V,…

Section 218.943 Permit Conditions (Repealed) (Source: Repealed at 18 Ill. Reg. 1945, effective January 24, 1994)

Section 218.946 Control Requirements Every owner or operator of a miscellaneous formulation manufacturing process emission unit subject to this Subpart shall comply with the requirements of subsection (a) or (b) below. a) Emission capture and control techniques which achieve an o…

Section 218.947 Compliance Schedule Every owner or operator of an emission unit subject to the control requirements of this Subpart shall comply with the requirements thereof on and after a date consistent with Section 218.106 of this Part. (Source: Amended at 17 Ill. Reg. 16636,…

Section 218.948 Testing a) When in the opinion of the Agency it is necessary to conduct testing to demonstrate compliance with Section 218.946 of this Part, the owner or operator of a VOM emission unit subject to the requirements of this Subpart shall, at his own expense, conduct…

Section 218.960 Applicability a) Maximum theoretical emissions: 1) A source is subject to this Subpart if it contains process emission units not regulated by Subparts B, E, F (excluding Section 218.204(l)), H (excluding Section 218.405), Q, R, S, T, (excluding Section 218.486) V,…

Section 218.963 Permit Conditions (Repealed) (Source: Repealed at 18 Ill. Reg. 1945, effective January 24, 1994)

Section 218.966 Control Requirements Every owner or operator of a miscellaneous organic chemical manufacturing process emission unit subject to this Subpart shall comply with the requirements of subsection (a), (b), or (c) of this Section. a) Emission capture and control techniqu…

Section 218.967 Compliance Schedule Every owner or operator of an emission unit subject to the control requirements of this Subpart shall comply with the requirements of this Subpart on and after a date consistent with Section 218.106 of this Part. (Source: Amended at 17 Ill. Reg…

Section 218.968 Testing a) When in the opinion of the Agency it is necessary to conduct testing to demonstrate compliance with Section 218.966 of this Part, the owner or operator of a VOM emission unit subject to the requirements of this Subpart shall, at his own expense, conduct…

Section 218.980 Applicability a) Maximum theoretical emissions: 1) A source is subject to this Subpart if it contains process emission units not regulated by Subparts B, E, F (excluding Section 218.204(l) of this Part), H (excluding Section 218.405 of this Part), Q, R, S, T (excl…

Section 218.983 Permit Conditions (Repealed) (Source: Repealed at 18 Ill. Reg. 1945, effective January 24, 1994)

Section 218.986 Control Requirements Every owner or operator of an emission unit subject to this Subpart shall comply with the requirements of subsection (a), (b), (c), (d), or (e) below. a) Emission capture and control equipment which achieves an overall reduction in uncontrolle…

Section 218.987 Compliance Schedule Every owner or operator of an emissions unit which is subject to this Subpart shall comply with the requirements of this Subpart on and after a date consistent with Section 218.106 of this Part. (Source: Amended at 17 Ill. Reg. 16636, effective…

Section 218.988 Testing a) When in the opinion of the Agency it is necessary to conduct testing to demonstrate compliance with Section 218.986 of this Part, the owner or operator of a VOM emission unit subject to the requirements of this Subpart shall, at his own expense, conduct…

Section 218.990 Exempt Emission Units Upon request by the Agency, the owner or operator of an emission unit which is exempt from the requirements of Subparts PP, QQ, RR, TT or Section 218.208(b) of this Part shall submit records to the Agency within 30 calendar days from the date…

Section 218.991 Subject Emission Units a) Any owner or operator of a VOM emission unit which is subject to the requirements of Subpart PP, QQ, RR or TT and complying by the use of emission capture and control equipment shall comply with the following: 1) By a date consistent with…

Section 218.APPENDIX A List of Chemicals Defining Synthetic Organic Chemical and Polymer Manufacturing CAS No.a Chemical 105-57-7 Acetal 75-07-0 Acetaldehyde 107-89-1 Acetaldol 60-35-5 Acetamide 103-84-4 Acetanilide 64-19-7 Acetic acid 108-24-7 Acetic anhydride 67-64-1 Acetone 75…

Section 219.100 Introduction a) This Part contains standards and limitations for emissions of organic material and volatile organic material from stationary sources located in the Metro East area, which is comprised of Madison, Monroe, and St. Clair Counties. b) Sources subject t…

Section 219.101 Savings Clause a) Every owner or operator of an emission unit formerly subject to 35 Ill. Adm. Code 215 shall have complied with its standards and limitations by the dates and schedules applicable to the emission unit in accordance with Part 215 or upon initial st…

Section 219.102 Abbreviations and Conversion Factors The abbreviations and conversion factors of 35 Ill. Adm. Code 211 apply to this Part. (Source: Amended at 17 Ill. Reg. 16918, effective September 27, 1993)

Section 219.103 Applicability The provisions of this Part shall apply to all sources located in Madison, Monroe, and St. Clair Counties.

Section 219.104 Definitions The definitions of 35 Ill. Adm. Code 211 apply to this Part. (Source: Amended at 17 Ill. Reg. 16918, effective September 27, 1993)

Section 219.105 Test Methods and Procedures a) Coatings, Inks and Fountain Solutions The following test methods and procedures must be used to determine compliance of as applied coatings, inks, and fountain solutions with the limitations set forth in this Part. 1) Sampling: Sampl…

Section 219.106 Compliance Dates a) Except as provided in subsection (b), (c), (d), (e), or (f), compliance with the requirements of this Part is required by May 15, 1992, consistent with the provisions of Section 219.103. b) As this Part is amended from time to time, compliance …

Section 219.107 Operation of Afterburners The operation of any natural gas fired afterburner and capture system used to comply with this Part is not required during the period of November 1 of any year to April 1 of the following year provided that the operation of such devices i…

Section 219.108 Exemptions, Variations, and Alternative Means of Control or Compliance Determinations Notwithstanding the provisions of any other Sections of this Part: a) Any exemptions, variations or alternatives to the control requirements, emission limitations, or test method…

Section 219.109 Vapor Pressure of Volatile Organic Liquids a) If the VOL consists of only a single compound, the vapor pressure shall be determined by ASTM Method D2879-86 (incorporated by reference in Section 219.112 of this Part) or the vapor pressure may be obtained from a pub…

Section 219.110 Vapor Pressure of Organic Material or Solvent a) If the organic material or solvent consists of only a single compound, the vapor pressure must be determined by ASTM Method D2879-86 (incorporated by reference in Section 219.112 of this Part) or the vapor pressure …

Section 219.111 Vapor Pressure of Volatile Organic Material a) If the VOM consists of only a single compound, the vapor pressure shall be determined by ASTM Method D2879-86 (incorporated by reference in Section 219.112 of this Part) or the vapor pressure may be obtained from a pu…

Section 219.112 Incorporations by Reference The following materials are incorporated by reference and do not contain any subsequent additions or amendments: a) American Society for Testing and Materials, 100 Barr Harbor Drive, West Conshohocken PA 19428-9555 1) ASTM D 2879-86 2) …

Section 219.113 Monitoring for Negligibly-Reactive Compounds The requirements of 35 Ill. Adm. Code 215.109, which allows the Agency to require testing and monitoring for negligibly-reactive compound as a precondition to their exemption from the definition of "volatile organic com…

Section 219.119 Applicability for VOL The limitations of Section 219.120 of this Subpart shall apply to all storage containers of volatile organic liquid (VOL) with a maximum true vapor pressure of 0.5 psia or greater in any stationary tank, reservoir, or other container of 151 c…

Section 219.120 Control Requirements for Storage Containers of VOL a) Every owner or operator storing VOL in a vessel of 40,000 gallons or greater with a maximum true vapor pressure equal to 0.75 psia but less than 11.1 psia shall reduce VOM emissions from storage tanks, reservoi…

Section 219.121 Storage Containers of VPL No person shall cause or allow the storage of any volatile petroleum liquid (VPL) with a vapor pressure of 10.34 kPa (1.5 psia) or greater at 294.3° K (70°F) or any gaseous organic material in any stationary tank, reservoir or other conta…

Section 219.122 Loading Operations a) No person shall cause or allow the discharge of more than 3.6 kg/hr (8lbs/hr) of organic material into the atmosphere during the loading of any organic material from the aggregate loading pipes of any loading area having through-put of greate…

Section 219.123 Petroleum Liquid Storage Tanks a) The requirements of subsection (b) of this Section shall not apply to any stationary storage tank: 1) Equipped before January 1, 1979 with one of the vapor loss control devices specified in Section 219.121(b) of this Part, except …

Section 219.124 External Floating Roofs a) In addition to meeting the requirements of Section 219.123(b) of this Part, no owner or operator of a stationary storage tank equipped with an external floating roof shall cause or allow the storage of any volatile petroleum liquid in th…

Section 219.125 Compliance Dates Every owner or operator of a VOL or VPL storage vessel subject to the requirements of this Subpart shall comply with the requirements of this Subpart in accordance with the compliance schedule specified in the applicable subsection below: a) Every…

Section 219.126 Compliance Plan (Repealed) (Source: Repealed at 17 Ill. Reg. 16918, effective September 27, 1993)

Section 219.127 Testing VOL Operations The owner or operator of each storage vessel specified in Section 219.119 of this Subpart shall comply with the requirements of subsection (a), (b), or (c) below. The applicable subsection for a particular storage vessel depends on the contr…