Michigan Administrative Code

R 325.10705 Collection and analysis of samples for coliform bacteria; community water systems. Rule 705. (1) A supplier of water of a community water system shall collect samples of water to be analyzed for the presence of coliform bacteria at sites which are representative of wa…

R 792.10705 Evidence; objections; rulings. Rule 705. (1) Evidence in a contested case may be received, maintained, distributed, subpoenaed, and admitted pursuant to the act, 1969 PA 306, MCL 24.271 to 24.287. (2) Evidence may be retained in the custody of a person designated by t…

R 325.10706 Collection and analysis of samples for coliform bacteria; noncommunity water system. Rule 706. (1) A supplier of a noncommunity water system shall collect samples for total coliform analysis at sites representative of the water throughout the distribution system accor…

R 792.10706 Depositions; interrogatories; requests for admissions. Rule 706. (1) A deposition, written interrogatories, or deposition on written interrogatories may be taken in a contested case pursuant to the Michigan court rules for use as evidence only and not for purposes of …

R 792.10707 Burden of proof. Rule 707. (1) The complaining party has the burden of proving, by a preponderance of the evidence, which grounds exist for the imposition of a sanction on a licensee, registrant, or applicant. (2) A petitioner for reinstatement or reclassification of …

R 325.10707 Repeat monitoring for coliform bacteria. Rule 707. (1) If a routine sample is total coliform-positive, a supplier of water shall collect a set of repeat samples within 24 hours of being notified of the positive result. If a supplier of water is required to collect mor…

R 325.10708 Collection of additional samples. Rule 708. (1) A single sample shall not be attributed to more than 1 monitoring period. (2) If a sample that is needed to meet monitoring requirements is invalidated under these rules, and the public water supply does not learn of the…

R 792.10708 Administrative law judge; impartiality. Rule 708. (1) A hearing shall be conducted by an administrative law judge designated by the department. The administrative law judge shall remain impartial and shall avoid even the appearance of partiality. (2) A member of a boa…

R 792.10709 Witnesses. Rule 709. (1) Upon motion and a showing of good cause, a prospective witness may be excluded from a hearing. (2) Upon motion and a showing of good cause, a witness who has testified may be instructed not to communicate with a prospective witness regarding t…

R 325.10709 Special purpose and invalidated samples. Rule 709. Special purpose samples, such as those taken following water main placement, replacement or repair, and samples invalidated pursuant to the provisions of R 325.10707a shall not be used to determine compliance with the…

R 325.10710 Collection and analysis of samples for inorganic chemicals. Rule 710. (1) Suppliers of water of community and noncommunity water systems shall collect water samples and cause analyses to be made for inorganic chemicals to determine compliance with the state drinking w…

R 792.10710 Rehearing. Rule 710. (1) If a final order has not been issued, a party may file a written request for rehearing with the administrative law judge pursuant to section 87 of the act, 1969 PA 306, MCL 24.287. The request shall expressly set forth the reasons for the rehe…

R 408.10711 Flywheels. Rule 711. An employer shall ensure that any part of a flywheel 7 feet or less above the floor or platform is guarded in 1 of the following ways: (a) Enclosed by a guard pursuant to R 408.10751 to R 408.10754. (b) With guardrail systems placed not less than …

R 792.10712 Limited license; reclassification; standards and procedures. Rule 712. (1) The limitations on a license shall continue until the expiration of the period of limitation set forth in the order or until the license is reclassified pursuant to this rule, whichever is late…

R 408.10712 Cranks and connecting rods. Rule 712. A crank and a connecting rod, if exposed to contact, must be guarded pursuant to R 408.10751 to R 408.10754 or by a guardrail system in compliance with General Industry Safety and Health Standard Part 2. “Walking-Working Surfaces,…

R 408.10713 Tail rods and extension piston rods. Rule 713. Tail rods and extension piston rods exposed to contact must be guarded pursuant to R 408.10751 to R 408.10754 or by a guardrail system in compliance with General Industry Safety and Health Standard Part 2. “Walking-Workin…

R 792.10713 Relicensure. Rule 713. Within 30 days after an application for relicensure or registration is filed, the complaining party may file a response to the application. If the response opposes relicensure or reregistration, a hearing shall be scheduled. If the petitioner fa…

R 792.10714 Affidavits. Rule 714. (1) An affidavit in support of a petition for reinstatement or reclassification shall set forth the facts which would support a finding that the requirements and conditions have been satisfied and shall be executed by a person who is able to comp…

R 408.10715 Discharge or exhaust pipes. Rule 715. The discharge of an exhaust pipe or boiler blowoff, if exposed to contact, shall be guarded pursuant to R 408.10751 to R 408.10754. History: 1979 AC; 1982 AACS.

R 408.10716 Revolving and reciprocating parts. Rule 716. A revolving or reciprocating part, if exposed to contact, shall be guarded pursuant to R 408.10751 to R 408.10754. History: 1979 AC; 1982 AACS.

R 325.10716 Collection and analysis of samples for VOCs. Rule 716. (1) Beginning with the initial compliance period, suppliers of community and nontransient, noncommunity water supplies shall collect samples and cause analyses to be made under this rule for volatile organic chemi…

R 325.10717 Collection and analysis of samples for synthetic organic chemicals. Rule 717. (1) Suppliers of community and nontransient, noncommunity water supplies shall collect samples and cause analyses to be made under this rule for synthetic organic chemicals to determine comp…

R 325.10720 Filtration and disinfection; filtration sampling requirements. Rule 720. (1) Subpart H supplies shall monitor under this rule to determine compliance with R 325.10611a and R 325.10611b. (2) All of the following provisions are turbidity monitoring requirements: (a) Sup…

R 408.10721 Shafts. Rule 721. (1) A continuous line of shafting shall be secured in position against endwise movement. (2) An inclined or vertical shaft will be held in position against endwise trust. (3) A project shaft end, if exposed to contact, shall be made flush or guarded …

R 325.10722 Filtration and disinfection; disinfection profiling and benchmarking. Rule 722. (1) A subpart H supply making a significant change to its disinfection practice, as described in subrule (4)(a)(i) to (iv) of this rule shall consult with the department before making the …

R 408.10722 Shafting. Rule 722. (1) Shafting exposed to contact 7 feet or less above a floor or platform level shall be guarded pursuant to R 408.10751 to R 408.10754. (2) Horizontal shafting extending over a driveway shall be guarded with a trough guard unless it is located 15 f…

R 325.10725 Radionuclides; applicability; monitoring generally; reporting. Rule 725. (1) A community water supply, also known as "supply" in this rule, R 325.10726, R 325.10728, R 325.10729, and R 325.10730, shall monitor to determine compliance with R 325.10603 and report to the…

R 408.10725 Pulley guards and guides. Rule 725. (1) A pulley and a pulley part exposed to contact 7 feet or less from the floor or platform shall be guarded pursuant to R 408.10751 to R 408.10754. (2) If the distance from a pulley to the nearest fixed pulley, clutch, or hanger is…

R 408.10726 Pulley condition and operation. Rule 726. (1) A pulley with a defect, including, but not limited to, a crack or a piece broken out, shall not be used. (2) A pulley subject to active corrosive conditions shall be of corrosion- resisting material. (3) A pulley permanent…

R 325.10726 Radionuclides; initial monitoring for gross alpha particle activity, radium-226, radium-228, and uranium. Rule 726. (1) A community water supply shall conduct initial monitoring for gross alpha particle activity, radium-226, radium-228, and uranium to determine compli…

R 408.10727 Belts. Rule 727. (1) A belt and pulley that is 7 feet or less above the floor or platform and that is exposed to contact must be guarded pursuant to R 408.10751 to R 408.10754. In a power plant or power-development room, a guardrail system may be used in compliance wi…

R 325.10728 Radionuclides; reduced monitoring for gross alpha particle activity, radium-226, radium-228, and uranium. Rule 728. (1) The department may allow community water supplies to reduce the future frequency of monitoring from once every 3 years to once every 6 or 9 years at…

R 325.10729 Radionuclides; compositing; substituting gross alpha for radium-226 or uranium. Rule 729. (1) To fulfill quarterly monitoring requirements for gross alpha particle activity, radium-226, radium-228, or uranium, a supply may composite up to 4 consecutive quarterly sampl…

R 408.10729 Cone pulley belts. Rule 729. (1) A cone belt and pulley shall be equipped with a belt shifter so constructed as to adequately guard the nip-point of the belt and pulley. If the frame of the belt shifter does not adequately guard the nip-point of the belt and pulley, t…

R 408.10730 Belt tighteners and counterweights. Rule 730. (1) A suspended counterbalanced belt tightener and its parts shall be provided with a safety cable or device to prevent the tightener from being exposed to contact if the belt breaks or they shall be guarded pursuant to R …

R 325.10730 Radionuclides; monitoring requirements for beta particle and photon radioactivity; applicability. Rule 730. (1) To determine compliance with the maximum contaminant levels in R 325.10603(2)(c) for beta particle and photon radioactivity, a community water supply, also …

R 325.10731 Sample analyses; approved laboratories and personnel. Rule 731. For the purpose of determining compliance with the monitoring requirements prescribed by this part, samples shall be considered valid only if they have been analyzed by a laboratory approved by the depart…

R 408.10731 Gears, sprockets, and chain drives. Rule 731. (1) Gears, sprockets, and chain drives exposed to contact shall be guarded pursuant to R 408.10751 to R 408.10754. This does not apply to hand- operated gear sprockets and chain drives used to adjust machine parts which do…

R 325.10732 Specific testing frequencies; sample locations and parameters. Rule 732. (1) The department may require a supplier of water to monitor raw water, water during stages in the treatment system if treatment is employed, and water from the distribution system at frequencie…

R 325.10733 Modification of monitoring requirements for type I public water supplies which supply water to additional public water supplies. Rule 733. When a type I public water supply supplies water to 1 or more other public water supplies, the department may modify the monitori…

R 325.10734 Required reporting to the department. Rule 734. (1) Unless otherwise specified in this part, a supplier of water shall report to the department the results of a measurement or analysis required by this part within the first 10 days of the month following the month in …

R 408.10734 Friction drives. Rule 734. The driving points and moving parts of friction drives, if exposed to contact, shall be guarded pursuant to R 408.10751 to R 408.10754. History: 1979 AC; 1982 AACS.

R 325.10735 Vigilance of threats or hazards; notification to department. Rule 735. (1) A public water supply shall maintain continued vigilance of activities posing threats or hazards of undue contamination to the source of water. (2) In the event of a threat of contamination of …

R 408.10736 Projections. Rule 736. Projecting keys, set screws, and other projections in revolving parts exposed to contact shall be removed, made flush, or guarded. This does not apply to keys or set screws within gear or sprocket casings or other enclosures, nor to keys, set sc…

R 325.10739 Groundwater supply rules; groundwater source microbial monitoring and analytical methods. Rule 739. (1) All of the following provisions apply to triggered source water monitoring in a groundwater supply that is subject to R 325.10612: (a) A groundwater supply shall co…

R 408.10741 Clutches. Rule 741. (1) A clutch, cut-off coupling, or clutch pulley having any projecting parts exposed to contact shall be enclosed by a stationary guard constructed pursuant to R 408.10751 to R 408.10754. (2) On a line shaft the shifting part of a jaw clutch and th…

R 408.10743 Belt shifters. Rule 743. (1) A tight pulley and a loose pulley shall be equipped with a permanent belt shifter provided with mechanical means to prevent the belt from creeping from the loose to the tight pulley. Page 9 Courtesy of Michigan Administrative Rules (2) A b…