7011 STANDARDS FOR STATIONARY SOURCES

7011.0060 DEFINITIONS. Subpart 1. Scope. The definitions in parts 7005.0100 and 7007.0100 apply to the terms used in parts 7011.0060 to 7011.0080 unless the terms are defined in this part. The definitions in this part apply to the terms used in parts 7011.0060 to 7011.0080. Subp.…

7011.0061 INCORPORATION BY REFERENCE. For the purpose of parts 7011.0060 to 7011.0080, the document, Industrial Ventilation - A Manual of Recommended Practice, American Conference of Governmental Industrial Hygienists (1984), 1300 Kemper Meadow Drive, Cincinnati, Ohio 45240, is i…

7011.0065 APPLICABILITY. Subpart 1. Applicability. The owner or operator of a stationary source must comply with parts 7011.0060 to 7011.0080 if the owner or operator elected to use the control equipment efficiencies for listed control equipment established pursuant to part 7011.…

7011.0070 LISTED CONTROL EQUIPMENT AND CONTROL EQUIPMENT EFFICIENCIES. Subpart 1. Listed control equipment efficiencies. A. Unless a part 70, state, or general permit specifies a different control efficiency, the owner or operator of a stationary source must at all times attain a…

7011.0072 REQUIREMENTS FOR CERTIFIED HOODS. Subpart 1. Applicability. This part applies only to certified hoods and hoods the owner or operator elects to be certified. Nothing in this part shall be construed to allow the owner or operator of an emission facility to violate an app…

7011.0075 LISTED CONTROL EQUIPMENT GENERAL REQUIREMENTS. Subpart 1. Operating control equipment. The owner or operator of a stationary source shall operate all listed control equipment located at the stationary source whenever operating the emission units controlled by the listed…

7011.0080 MONITORING AND RECORD KEEPING FOR LISTED CONTROL EQUIPMENT. The owner or operator of a stationary source must comply with the monitoring and record keeping required for listed control equipment by the table in this part. The owner or operator shall maintain the records …

7011.0100 SCOPE. The standards of performance in parts 7011.0100 to 7011.0115 apply to any emission facility for which a specific standard of performance has not been promulgated in another rule. Statutory Authority: MS s 116.07 History: 18 SR 614 Published Electronically: Februa…

7011.0105 VISIBLE EMISSIONS; RESTRICTIONS FOR EXISTING FACILITIES. No owner or operator of an existing emission facility to which parts 7011.0100 to 7011.0115 are applicable shall cause to be discharged into the atmosphere from the facility any gases which exhibit greater than 20…

7011.0110 VISIBLE EMISSIONS; RESTRICTIONS FOR NEW FACILITIES. No owner or operator of a new emission facility to which parts 7011.0100 to 7011.0115 are applicable shall cause to be discharged into the atmosphere from the facility any gases which exhibit greater than 20 percent op…

7011.0115 PERFORMANCE TESTS. Unless another method is approved by the commissioner, any person required to submit performance tests for emission facilities for which parts 7011.0100 to 7011.0115 are applicable shall utilize Method 9 for visual determination of opacity. Performanc…

7011.0120 ADJUSTING OPACITY STANDARD. Subpart 1. Application for permit modification. An owner or operator of an emission facility may file an application for a permit modification under chapter 7007 for adjustment of the opacity standard applicable to an emissions unit. In addit…

7011.0150 PREVENTING PARTICULATE MATTER FROM BECOMING AIRBORNE. A. No person shall cause or permit the handling, use, transporting, or storage of any material in a manner which may allow avoidable amounts of particulate matter to become airborne. B. No person shall cause or permi…

7011.0300 [Repealed, 21 SR 693] Published Electronically: February 25, 2008

7011.0305 [Repealed, 21 SR 693] Published Electronically: February 25, 2008

7011.0310 [Repealed, 21 SR 693] Published Electronically: February 25, 2008

7011.0315 [Repealed, 21 SR 693] Published Electronically: February 25, 2008

7011.0320 [Repealed, 21 SR 693] Published Electronically: February 25, 2008

7011.0325 [Repealed, 21 SR 693] Published Electronically: February 25, 2008

7011.0330 [Repealed, 21 SR 693] Published Electronically: February 25, 2008

7011.0400 [Repealed, 22 SR 1237] Published Electronically: February 25, 2008

7011.0405 [Repealed, 22 SR 1237] Published Electronically: February 25, 2008

7011.0410 [Repealed, 22 SR 1237] Published Electronically: February 25, 2008

7011.0500 DEFINITIONS. Subpart 1. Scope. As used in parts 7011.0500 to 7011.0550, the following words shall have the meanings defined herein. Subp. 2. Actual heat input. "Actual heat input" means the number of Btu per hour (cal/hr) determined by multiplying the gross heating valu…

7011.0505 DETERMINING APPLICABLE STANDARDS OF PERFORMANCE. Subpart 1. Scope. Parts 7011.0500 to 7011.0550 shall apply to indirect heating equipment for which a standard of performance has not been promulgated in a specific rule. Subp. 2. Rated heat input. The applicable standards…

7011.0510 STANDARDS OF PERFORMANCE FOR EXISTING INDIRECT HEATING EQUIPMENT. Subpart 1. Particulate matter and sulfur dioxide. No owner or operator of existing indirect heating equipment shall cause to be discharged into the atmosphere from said equipment any gases that contain fi…

7011.0515 STANDARDS OF PERFORMANCE FOR NEW INDIRECT HEATING EQUIPMENT. Subpart 1. Particulate matter, sulfur dioxide, and nitrogen oxides. No owner or operator of new indirect heating equipment shall cause to be discharged into the atmosphere from said equipment any gases that co…

7011.0520 ALLOWANCE FOR STACK HEIGHT FOR INDIRECT HEATING EQUIPMENT. Subpart 1. Requirement. The owner or operator of any indirect heating equipment shall determine and install a stack of such height that will not cause pollutant concentrations at ground levels to exceed any appl…

7011.0525 HIGH HEATING VALUE. The high heating value of a fossil fuel shall mean the same as the gross heating value. Statutory Authority: MS s 116.07 History: 18 SR 614 Published Electronically: February 25, 2008

7011.0530 PERFORMANCE TEST METHODS. Unless another method is approved by the commissioner, any person required to submit performance tests for indirect heating equipment must use the following test methods to demonstrate compliance: A. Method 1 for selection of sampling site and …

7011.0535 PERFORMANCE TEST PROCEDURES. Subpart 1. In general. Performance tests shall be conducted according to the requirements of this part and parts 7017.2001 to 7017.2060. Subp. 2. Method 1. The sampling site, as selected by Method 1, shall be the same for each pollutant duri…

7011.0540 DERATE. The owner or operator of indirect heating equipment who elects to achieve compliance with an applicable standard of performance by derating must: A. advise the commissioner in writing of the intent to achieve compliance by derating and the capacity level at whic…

7011.0545 TABLE I: EXISTING INDIRECT HEATING EQUIPMENT. Statutory Authority: MS s 116.07 History: 18 SR 614 Published Electronically: February 25, 2008

7011.0550 TABLE II: NEW INDIRECT HEATING EQUIPMENT. Statutory Authority: MS s 116.07 History: 18 SR 614 Published Electronically: February 25, 2008

7011.0551 RECORD KEEPING AND REPORTING FOR INDIRECT HEATING UNITS COMBUSTING SOLID WASTE. Subpart 1. Application. The owner or operator of indirect heating equipment combusting mixed municipal solid waste or refuse-derived fuel which makes up 30 percent or less by weight of total…

7011.0553 INCORPORATION BY REFERENCE; NITROGEN OXIDES EMISSION REDUCTION REQUIREMENTS FOR AFFECTED SOURCES. Affected sources, as defined in part 7007.0100, subpart 4, must comply with Code of Federal Regulations, title 40, part 76, as amended, entitled "Acid Rain Nitrogen Oxides …

7011.0555 INCORPORATION BY REFERENCE; NEW SOURCE PERFORMANCE STANDARDS; FOSSIL-FUEL-FIRED STEAM GENERATORS. Code of Federal Regulations, title 40, part 60, subpart D, as amended, entitled "Standards of Performance for Fossil-Fuel-Fired Steam Generators," is incorporated by refere…

7011.0560 INCORPORATION BY REFERENCE; NEW SOURCE PERFORMANCE STANDARDS; ELECTRIC UTILITY STEAM GENERATING UNITS. Code of Federal Regulations, title 40, part 60, subpart Da, as amended, entitled "Standards of Performance for Electric Utility Steam Generating Units," is incorporate…

7011.0561 CONTROL OF MERCURY FROM ELECTRIC GENERATING UNITS. Subpart 1. Applicability. The owners or operators of a coal-fired electric generating unit that have demonstrated actual mercury emissions of five pounds per year or more must comply with this part, except as provided u…

7011.0562 INCORPORATION BY REFERENCE; NEW SOURCE PERFORMANCE STANDARDS; GREENHOUSE GAS EMISSIONS FOR ELECTRIC GENERATING UNITS. Code of Federal Regulations, title 40, part 60, subpart TTTT, as amended through July 1, 2018, entitled "Standards of Performance for Greenhouse Gas Emi…

7011.0563 INCORPORATION BY REFERENCE; EMISSION STANDARDS; COAL- AND OIL-FIRED ELECTRIC UTILITY STEAM GENERATORS. Code of Federal Regulations, title 40, part 63, subpart UUUUU, as amended through July 1, 2018, entitled "National Emission Standards for Hazardous Air Pollutants: Coa…

7011.0565 INCORPORATION BY REFERENCE; NEW SOURCE PERFORMANCE STANDARDS; STEAM GENERATING UNITS. Code of Federal Regulations, title 40, part 60, subpart Db, as amended, entitled "Standards of Performance for Industrial-Commercial-Institutional Steam Generating Units," is incorpora…

7011.0570 INCORPORATION BY REFERENCE; NEW SOURCE PERFORMANCE STANDARDS; SMALL STEAM GENERATING UNITS. Code of Federal Regulations, title 40, part 60, subpart Dc, as amended, entitled "Standards of Performance for Small Industrial-Commercial-Institutional Steam Generating Units," …

7011.0600 DEFINITIONS. Subpart 1. Scope. As used in parts 7011.0600 to 7011.0620, the following words shall have the meanings defined herein. Subp. 2. Actual heat input. "Actual heat input" means the number of Btu per hour (cal/hr) determined by multiplying the gross heating valu…

7011.0605 DETERMINING APPLICABLE STANDARDS OF PERFORMANCE. A. Parts 7011.0600 to 7011.0620 shall apply to direct heating equipment for which a standard of performance has not been promulgated in a specific rule. B. The applicable standard of performance for sulfur dioxide shall b…

7011.0610 PERFORMANCE STANDARDS; FOSSIL-FUEL-BURNING DIRECT HEATING EQUIPMENT. Subpart 1. Particulate matter; limitations. A. No owner or operator of any direct heating equipment shall cause to be discharged into the atmosphere from the direct heating equipment any gases that: (1…

7011.0615 PERFORMANCE TEST METHODS. Unless another method is approved by the commissioner, any person required to submit performance tests for direct heating equipment must use the following test methods to demonstrate compliance: A. Method 1 for selection of sampling site and sa…