7011 STANDARDS FOR STATIONARY SOURCES

7011.0705 SCOPE. Parts 7011.0700 to 7011.0735 shall apply to industrial process equipment for which a standard of performance has not been promulgated in a specific rule. Statutory Authority: MS s 116.07 History: 18 SR 614 Published Electronically: February 25, 2008

7011.0710 PERFORMANCE STANDARDS; PRE-1969 INDUSTRIAL PROCESS EQUIPMENT. Subpart 1. Prohibited discharge of gases. No owner or operator of any industrial process equipment that was in operation before July 9, 1969, shall cause to be discharged into the atmosphere from the industri…

7011.0715 STANDARDS OF PERFORMANCE FOR POST-1969 INDUSTRIAL PROCESS EQUIPMENT. Subpart 1. Prohibited discharge of gases. No owner or operator of any industrial process equipment that was not in operation before July 9, 1969, shall cause to be discharged into the atmosphere from t…

7011.0720 PERFORMANCE TEST METHODS. Unless another method is approved by the commissioner, any owner or operator required to submit performance tests for any industrial process equipment must use the following test methods to demonstrate compliance: A. Method 1 for sample and vel…

7011.0725 [Repealed, 41 SR 763] Published Electronically: January 27, 2017

7011.0730 TABLE 1. Process Weight Rate (pounds/hour) Emission Rate (pounds/hour) 100 0.55 500 1.53 1,000 2.25 5,000 6.34 10,000 9.73 20,000 14.99 60,000 29.60 80,000 31.19 120,000 33.28 160,000 34.85 200,000 36.11 400,000 40.35 1,000,000 46.72 Interpolation of the data in this pa…

7011.0735 TABLE 2. Source Gas Volume, DSCFMa Concentration GR/DSCFb 7,000 or less 0.100 8,000 0.096 9,000 0.092 10,000 0.089 20,000 0.071 30,000 0.062 40,000 0.057 50,000 0.053 60,000 0.050 80,000 0.045 100,000 0.042 120,000 0.040 140,000 0.038 160,000 0.036 180,000 0.035 200,000…

7011.0800 [Repealed, 23 SR 2224] Published Electronically: February 25, 2008

7011.0805 [Repealed, 23 SR 2224] Published Electronically: February 25, 2008

7011.0810 [Repealed, 18 SR 580] Published Electronically: February 25, 2008

7011.0815 [Repealed, 23 SR 2224] Published Electronically: February 25, 2008

7011.0820 [Repealed, 23 SR 2224] Published Electronically: February 25, 2008

7011.0825 [Repealed, 23 SR 2224] Published Electronically: February 25, 2008

7011.0830 INCORPORATION BY REFERENCE; NEW SOURCE PERFORMANCE STANDARDS; PORTLAND CEMENT PLANTS. Code of Federal Regulations, title 40, part 60, subpart F, as amended, entitled "Standards of Performance for Portland Cement Plants," is incorporated by reference. Statutory Authority…

7011.0850 DEFINITIONS. Subpart 1. Scope. The definition in this part applies to the terms used in parts 7011.0850 to 7011.0859. The definitions in parts 7005.0100, 7007.0100, and 7011.0060 apply to the terms used in parts 7011.0850 to 7011.0859, unless the terms are otherwise def…

7011.0852 STANDARDS OF PERFORMANCE FOR CONCRETE MANUFACTURING PLANTS. No owner or operator of a concrete manufacturing plant shall cause to be discharged into the atmosphere from the concrete manufacturing plant any emissions which: A. contain particulate matter in excess of the …

7011.0854 CONCRETE MANUFACTURING PLANT CONTROL EQUIPMENT REQUIREMENTS. Subpart 1. Operation of concrete manufacturing plant control equipment. Unless otherwise allowed in a state or part 70 permit, emissions during cementitious material receiving from cement silos and other cemen…

7011.0857 PREVENTING PARTICULATE MATTER FROM BECOMING AIRBORNE. A. No owner or operator of a concrete manufacturing plant shall cause or permit the handling, use, transporting, or storage of any material in a manner which may allow avoidable amounts of particulate matter to becom…

7011.0858 NOISE. The owner or operator of a concrete manufacturing plant shall comply with the noise pollution control rules in chapter 7030. Statutory Authority: MS s 116.07 History: 23 SR 1241 Published Electronically: February 25, 2008

7011.0859 SHUTDOWN AND BREAKDOWN PROCEDURES. In the event of a shutdown or breakdown of process or control equipment that causes any increase in emissions of any regulated air pollutant, the owner or operator of a stationary source shall comply with the notification, operation ch…

7011.0860 [Repealed, 27 SR 1579] Published Electronically: February 25, 2008

7011.0865 INCORPORATIONS BY REFERENCE; DOCUMENTS. A. For the purpose of part 7011.0870, the documents in items B and C are incorporated by reference. These documents are not subject to frequent change. B. California Environmental Protection Agency, Air Resources Board, Vapor Reco…

7011.0870 STAGE-ONE VAPOR RECOVERY. Subpart 1. Applicability. The owner or operator of a gasoline service station required to install and operate a stage-one vapor recovery system shall comply with this part. Subp. 2. System design. Stage-one vapor recovery systems must: A. confo…

7011.0900 DEFINITIONS. Subpart 1. Scope. The definitions in this part apply to the terms used in parts 7011.0900 to 7011.0920. The definitions in parts 7005.0100, 7007.0100, and 7011.0060 apply to the terms used in parts 7011.0900 to 7011.0920, unless the terms are defined in thi…

7011.0903 COMPLIANCE WITH AMBIENT AIR QUALITY STANDARDS. Subpart 1. Fuel sulfur content limitation. Notwithstanding part 7011.0913, no owner or operator of a hot mix asphalt plant shall use in the dryer burner any fuel with a sulfur content greater than 0.70 percent, unless: A. a…

7011.0905 STANDARDS OF PERFORMANCE FOR EXISTING HOT MIX ASPHALT PLANTS. No owner or operator of an existing hot mix asphalt plant shall cause to be discharged into the atmosphere from the hot mix asphalt plant any gases that: A. contain the sum of filterable and organic condensab…

7011.0909 INCORPORATION BY REFERENCE; NEW SOURCE PERFORMANCE STANDARDS; HOT MIX ASPHALT PLANTS. Code of Federal Regulations, title 40, part 60, subpart I, as amended, entitled "Standards of Performance for Hot Mix Asphalt Facilities," is incorporated by reference. Statutory Autho…

7011.0910 [Repealed, 18 SR 580] Published Electronically: February 25, 2008

7011.0911 MAINTENANCE OF DRYER BURNER. Subpart 1. Annual tuning of dryer burner. The owner or operator of a hot mix asphalt plant must tune the dryer burner for maximum combustion efficiency once each calendar year. Subp. 2. Daily check of dryer burner. The owner or operator of a…

7011.0913 HOT MIX ASPHALT PLANT MATERIALS, FUELS, AND ADDITIVES OPERATING REQUIREMENTS. Subpart 1. Materials, fuels, and additives allowed. Except as provided in subpart 3, the owner or operator of a hot mix asphalt plant is allowed to use only the materials, fuels, and additives…

7011.0915 [Repealed, 20 SR 2253(NO. 42)] Published Electronically: February 25, 2008

7011.0917 ASPHALT PLANT CONTROL EQUIPMENT REQUIREMENTS. Subpart 1. Operation of asphalt plant control equipment. The owner or operator of a hot mix asphalt plant shall operate in compliance with this part all asphalt plant control equipment located at the stationary source whenev…

7011.0920 PERFORMANCE TESTS. Subpart 1. Methods and procedures. Performance tests shall be conducted according to the requirements of this part and parts 7017.2001 to 7017.2060. Subp. 2. Performance test frequency for hot mix asphalt plants using fabric filters. If an owner or op…

7011.0922 OPERATIONAL REQUIREMENTS AND LIMITATIONS FROM PERFORMANCE TESTS. Subpart 1. Throughput limit. The owner or operator of a hot mix asphalt plant shall not exceed the production throughput at which compliance with part 7011.0905 or 7011.0909 was demonstrated during the pla…

7011.0925 [Renumbered 7011.0909] Published Electronically: February 25, 2008

7011.0950 INCORPORATION BY REFERENCE; NEW SOURCE PERFORMANCE STANDARDS; ASPHALT PROCESSING AND ASPHALT ROOFING MANUFACTURE. Code of Federal Regulations, title 40, part 60, subpart UU, as amended, entitled "Standards of Performance for Asphalt Processing and Asphalt Roofing Manufa…

7011.1000 DEFINITIONS. Subpart 1. Scope. For the purposes of parts 7011.1000 to 7011.1015, the following terms have the meanings given them. Subp. 2. Capture system. "Capture system" means equipment such as hoods, ducts, fans, and dampers used to capture particulate matter. Subp.…

7011.1005 STANDARDS OF PERFORMANCE FOR DRY BULK AGRICULTURAL COMMODITY FACILITIES. Subpart 1. Owner or operator duties. The owner or operator of a commodity facility must: A. clean up commodities spilled on the driveway and other facility property as required to minimize fugitive…

7011.1010 NUISANCE. Notwithstanding any provisions in parts 7011.1000 to 7011.1015, no owner or operator of a dry bulk agricultural commodity facility may operate or maintain a facility that creates a public nuisance. If the commissioner determines that operation or maintenance o…

7011.1015 CONTROL REQUIREMENTS SCHEDULE. Date Construction, Modification or Reconstruction Commenced Facility Description Prior to 1/1/84 After 1/1/84 Facility located in Minneapolis-Saint Paul Air Quality Control Region or located in a city with a population of 7,500 or more or …

7011.1100 DEFINITIONS. Subpart 1. Scope. As used in parts 7011.1100 to 7011.1140, the following words shall have the meanings defined herein. Subp. 2. Coal. "Coal" means any solid fossil fuel described as anthracite, bituminous, subbituminous, lignite, or coke (as derived from co…

7011.1105 STANDARDS OF PERFORMANCE FOR CERTAIN COAL HANDLING FACILITIES. The owner or operator of any new coal handling facility, or an existing coal handling facility located within the Minneapolis-St. Paul Air Quality Control Region or within the boundaries of the city of Dulut…

7011.1110 STANDARDS OF PERFORMANCE FOR EXISTING OUTSTATE COAL HANDLING FACILITIES. The owner or operator of an existing coal handling facility which is located outside the Minneapolis-Saint Paul Air Quality Control Region and outside the boundaries of the city of Duluth shall com…

7011.1115 STANDARDS OF PERFORMANCE FOR PNEUMATIC COAL-CLEANING EQUIPMENT AND THERMAL DRYERS AT ANY COAL HANDLING FACILITY. Subpart 1. Pneumatic coal-cleaning equipment. The owner or operator of a coal handling facility shall not cause to be discharged into the atmosphere from any…

7011.1120 EXEMPTION. During freezing temperatures, owners or operators shall not be required to apply water or dust suppressants. Statutory Authority: MS s 116.07 History: 18 SR 614 Published Electronically: February 25, 2008

7011.1125 CEASING OPERATIONS; WIND. The owner or operator of a coal handling facility shall not conduct any nonessential coal handling operations that are not shielded from the wind or enclosed in a building when steady wind speeds exceed 30 miles per hour as determined at the ne…

7011.1130 PERFORMANCE TEST METHOD. Unless another method is approved by the commissioner, an owner or operator required to submit performance tests for coal handling facilities must use the following test methods to demonstrate compliance: A. Method 1 for sample and velocity trav…