Wisconsin Administrative Code

NR 281.12 Standards of performance. There shall be no discharge of process wastewater pollutants from a facility which is a new source subject to the provisions of this chapter. History: Cr. Register, June, 1977, No. 258, eff. 7-1-77.

NR 281.13 Pretreatment standards. The pretreatment standards for discharges to publicly owned treatment works from sources subject to the provisions of this chapter shall be as set forth in ch. NR 211. History: Cr. Register, June, 1977, No. 258, eff. 7-1-77; r. and recr. Register…

NR 283.01 Purpose. The purpose of this chapter is to establish effluent limitations and standards of performance for discharges of process wastes from the plastics molding and forming category of point sources and its subcategories. History: Cr. Register, October, 1987, No. 382, …

NR 283.015 Applicability. NR 283.02 General definitions. NR 283.03 Monitoring and reporting requirements. Subchapter II - Contact Cooling and Heating Water Subcategory NR 283.10 Applicability; description of the contact cooling and heating water subcategory. NR 283.11 Effluent li…

NR 283.02 General definitions. In addition to the definitions set forth in ch. NR 205 and s. NR 211.03, the following definitions apply to this chapter: (1) XAverage process water usage flow rateY means the volume of process water used per year by a plastics molding and forming p…

NR 283.03 Monitoring and reporting requirements. Compliance with the maximum monthly average effluent limitations and pretreatment standards listed in the tables for each regulated process is required regardless of the number of samples analyzed and averaged. The maximum monthly …

NR 283.10 Applicability; description of the contact cooling and heating water subcategory. This subchapter applies to the discharge of pollutants from processes in the contact cooling and heating water subcategory to waters of the state and the introduction of pollutants into POT…

NR 283.11 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. (1) Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subchapter shall…

NR 283.12 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Based on EPA[s determination that BPT provides adequate control of toxic pollutants in contact cooling and heating …

NR 283.13 New source performance standards. (1) Any new source subject to this subchapter shall achieve performance standards which are calculated by multiplying the average process water usage flow rate for the contact cooling and heating water processes at a new source times th…

NR 283.14 Pretreatment standards for existing sources. Any existing source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211. Note: PSES for bis(2-ethylhexyl) phthalate are reserved. History: Cr. Register, October, 1987, No. 382, eff. …

NR 283.15 Pretreatment standards for new sources. Any new source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211. Note: PSNS for bis(2-ethylhexyl) phthalate are reserved. History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.

NR 283.16 Effluent limitations representing the degree of effluent reduction attainable by the application of the best conventional pollutant control technology. (1) Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subchapter shall achieve …

NR 283.20 Applicability; description of the cleaning water subcategory. This subchapter applies to the discharge of pollutants from processes in the cleaning water subcategory to waters of the state and the introduction of pollutants into POTWs. The cleaning water subcategory is …

NR 283.21 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. (1) Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subchapter shall…

NR 283.22 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Based on EPA[s determination that BPT provides adequate control of toxic pollutants in cleaning process wastewater,…

NR 283.23 New source performance standards. (1) Any new source subject to this subchapter shall achieve performance standards calculated by multiplying the average process water usage flow rate for cleaning processes at a new source times the pollutant concentrations indicated in…

NR 283.24 Pretreatment standards for existing sources. Any existing source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211. History: Cr. Register, October, 1987, No. 382, eff. 11-1-87.

NR 283.25 Pretreatment standards for new sources. Any new source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211. History: Cr. Register, October, 1987, No. 382, eff. 11-1-87. Subchapter III - Cleaning Water Subcategory

NR 283.30 Applicability; description of the finishing water subcategory. This subchapter applies to the discharge of pollutants from processes in the finishing water subcategory to waters of the state and the introduction of pollutants into POTWs. The finishing water subcategory …

NR 283.31 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. (1) Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subchapter shall…

NR 283.32 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Based on EPA[s determination that BPT provides adequate control of toxic pollutants in finishing process wastewater…

NR 283.33 New source performance standards. (1) Any new source subject to this subchapter shall achieve performance standards which are calculated by multiplying the average process water usage flow rate for the finishing water processes at a new source times the pollutant concen…

NR 283.34 Pretreatment standards for existing sources. Any existing source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211. Note: PSES for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved. Histor…

NR 283.35 Pretreatment standards for new sources. Any new source subject to this subchapter that introduces pollutants into a POTW shall comply with ch. NR 211. Note: PSNS for bis(2-ethylhexyl) phthalate, di-n-butyl phthalate, and dimethyl phthalate are reserved. History: Cr. Reg…

NR 283.40 Cross-references. The federal citations in this chapter correspond to provisions of the Wisconsin administrative code and Wisconsin statutes. The federal citations may be cross-referenced in the following table: Code of Federal Regulations 40 CFR Part 463 40 CFR 125.30 …

NR 284.01 Purpose. The purpose of this chapter is to establish effluent limitations, standards of performance, and pretreatment standards for discharges of process wastes from the pulp and paper industry category of point sources and subcategories thereof. History: Cr. Register, …

NR 284.02 Applicability. The effluent limitations, standards of performance, pretreatment standards, and other provisions in this chapter are applicable to pollutants or pollutant properties in discharges of process waste resulting from activities in any or a combination of any o…

NR 284.03 Definitions. The following definitions are applicable to terms used in this chapter. Definitions of other terms and meanings of abbreviations are set forth in chs. NR 205 and 211, and the Development Document for Effluent Limitations Guidelines and Standards for the Pul…

NR 284.04 Application of effluent limitations and standards. (1) The production basis for application of the limitations and standards set forth in this chapter shall be the annual production divided by the number of operating days in the year for each subcategory subject to the …

NR 284.10 Applicability. The provisions in this subchapter are applicable to discharges of wastewater from the pulp and paper manufacturing category of point sources into waters of the state. History: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 284.11 Compliance dates. Discharge of pollutants from facilities subject to the provisions of this subchapter may not exceed, as appropriate: (1) By July 1, 1977 effluent limitations representing the degree of effluent reduction attainable by the application of the best practi…

NR 284.115 Measure of production. Paper or paperboard production shall be measured at the paper machine takeup reel in off-the-machine moisture content, except for the semichemical, unbleached kraft, unbleached kraft-neutral sulfite semi-chemical (cross recovery), and paperboard …

NR 284.20 Applicability. The provisions in this subchapter are applicable to discharges of wastewater from the pulp and paper manufacturing category of point sources into publicly owned treatment works. History: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 284.21 Compliance dates. Discharge of pollutants from facilities subject to the provisions of this subchapter may not exceed, as appropriate: (1) By July 1, 1984 for pretreatment standards for existing sources; (2) At the commencement of discharge for pretreatment standards fo…

NR 284.215 Measure of production. NR 284.22 Discharge standards. (c) Market bleached kraft subcategory. History: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 284.22 Discharge standards. (1) PRETREATMENT STANDARDS FOR EXISTING SOURCES (PSES). Except as provided in ss. NR 211.13 and 211.14 pertaining to removal credits and fundamentally different factors, any existing source subject to this section which introduces pollutants into a …

NR 286.01 Purpose. The purpose of this chapter is to establish limitations, standards of performance, and pretreatment standards for discharges of process wastes from the rubber processing category of point sources and subcategories thereof. Note: The authority for promulgation o…

NR 286.02 Applicability. (1) The effluent limitations, standards of performance, pretreatment standards, and other provision in this chapter are applicable to pollutants or pollutant properties in discharges of process waste resulting from manufacture in any of the following prod…

NR 286.03 Definitions. The following definitions are applicable to terms used in this chapter. Definitions of other terms and meanings of abbreviations are set forth in ch. NR 205. (1) XChromiumY or XCrY means total chromium (2) XLarge-sizedY means manufacturing plants which proc…

NR 286.04 Compliance with effluent limitations and standards. Discharge of pollutants from facilities subject to the provisions of this chapter may not exceed, as appropriate: (1) By July 1, 1977 effluent limitations representing the degree of effluent reduction attainable by the…

NR 286.06 Application of effluent limitations and standards. (1) The effluent limitations and standards set forth in this chapter shall be used in accordance with this section to establish the quantity or quality of pollutants or pollutant properties which may be discharged by a …

NR 286.09 Effluent limitations, non-process wastewater. The following effluent limitations are applicable to discharges of non-process wastewater, including tread cooling water, from facilities in the pneumatic tire and inner tube subcategory which were constructed before 1959. S…

NR 286.10 Effluent limitations, best practicable treatment. The following effluent limitations for all or specific subcategories establish, except as provided in subch. IV of ch. NR 220, the quantity or quality of pollutants or pollutant properties which may be discharged by a fa…

NR 286.11 Effluent limitations, best available treatment. The following effluent limitations for all or specific subcategories establish the quantity or quality of pollutants or pollutant properties which may be discharged by a facility subject to the provisions of this chapter a…

NR 286.12 Standards of performance. The following effluent limitations for all or specific subcategories establish the quantity or quality of pollutants or pollutant properties which may be discharged by a facility which is a new source subject to the provisions of this chapter. …

NR 286.13 Pretreatment standards. The pretreatment standards for discharges to publicly owned treatment works from sources subject to the provisions of this chapter shall be as set forth in ch. NR 211. History: Cr. Register, June, 1976, No. 246, eff. 7-1-76; r. and recr. Register…