Wisconsin Administrative Code

NR 260.23 Total toxic organics monitoring requirements. (1) In place of monitoring for TTO, the control authority may allow industrial users of publicly owned treatment works to make the following certification to replace the periodic reports required by s. NR 211.15: XBased on m…

NR 261.01 Purpose. The purpose of this chapter is to establish standards of performance and effluent limitations for discharges of wastewater from the metal finishing point source category into waters of the state. It is also the purpose of this chapter to establish pretreatment …

NR 261.02 Applicability. (1) The provisions of this chapter are applicable to dischargers performing any of the operations outlined in s. NR 260.02 (1) which include: electroplating of common metals, electroplating of precious metals, anodizing, coatings (chromating, phosphating …

NR 261.03 Definitions. The following definitions are applicable to terms used in this chapter. Definitions of other terms and meanings of abbreviations are set forth in chs. NR 205, 211, and 260, and the EPA Development Document for Effluent Limitations Guidelines and Standards f…

NR 261.10 Applicability. The provisions of this subchapter are applicable to discharges of wastewater from the metal finishing point source category directly into waters of the state. History: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 261.11 Compliance dates. Discharge of pollutants from facilities subject to the provisions of this subchapter may not exceed, as appropriate: (1) By July 1, 1977 effluent limitations representing the degree of effluent reduction attainable by the application of the best practi…

NR 261.12 Discharge standards. (1) BEST PRACTICA(a) Except as provided in par. (b) and subch. IV of ch. NR 220, any existing point source subject to this subchapter shall, no later than July 1, 1977, achieve the following effluent limitations attainable by applying the best pract…

NR 261.13 Monitoring requirements. (1) TOTAL TOXIC ORGANICS. (a) In place of monitoring for TTO, the department may allow dischargers to make the following certification statement: XBased on my inquiry of the person or persons directly responsible for managing compliance with the…

NR 261.20 Applicability. The provisions of this subchapter are applicable to discharges of wastewater from the metal finishing processes as listed in s. NR 261.02 (1) into publicly owned treatment works. History: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 261.21 Compliance dates. Discharge of pollutants from facilities subject to the provisions of this subchapter may not exceed as appropriate: (1) By February 15, 1986 for pretreatment standards for existing sources (PSES); (2) At the commencement of discharge for pretreatment s…

NR 261.22 Discharge standards. (1) PRETREATMENT (a) Except as provided in par. (b), any existing source subject to this subchapter shall comply with ch. NR 211 and achieve, by February 15, 1986, the following pretreatment standards for existing sources: Table 4 PSES (mg/l) STANDA…

NR 261.23 Monitoring requirements. (1) TOTAL TOXIC ORGANICS. (a) In place of monitoring for TTO, the control authority may allow dischargers to make the following certificationstatement: XBased on my inquiry of the person or persons directly responsible for managing compliance wi…

NR 262.01 Purpose. The purpose of this chapter is to establish effluent limitations, standards of performance, and pretreatment standards for discharges of process wastes from the porcelain enameling category of point sources and its subcategories. History: Cr. Register, October,…

NR 262.015 Applicability. (1) Except as provided in subs. (2) and (3), the provisions of this chapter apply to any porcelain enameling facility which discharges pollutants to waters of the state or introduces pollutants into a publicly owned treatment works. (2) Any existing porc…

NR 262.02 General definitions. In addition to the definitions set forth in 40 CFR Part 401, the following definitions apply to this chapter: (1) XArea coatedY means the area of basis material covered by each coating of enamel. (2) XArea processedY means the total basis material a…

NR 262.03 Monitoring and reporting requirements. (1) Periodic analyses for chromium as may be required under 40 CFR Part 122 or 403 is not required when both of the following conditions are met: (a) The first wastewater sample of each calendar year has been analyzed and found to …

NR 262.04 Compliance date for pretreatment standards for existing sources (PSES). The compliance date for pretreatment standards for existing sources is November 25, 1985. History: Cr. Register, October, 1986, No. 370, eff. 11-1-86.

NR 262.10 Applicability; description of the steel basis material subcategory. This subcategory applies to discharges to waters of the state and introduction of pollutants into publicly owned treatment works from porcelain enameling on steel basis materials. History: Cr. Register,…

NR 262.11 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subcategory shall ac…

NR 262.12 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Except as provided in 40 CFR 125.30 to 125.32 any existing point source subject to this subcategory shall achieve t…

NR 262.13 New source performance standards. Any new source subject to this subcategory shall achieve the following new source performance standards: NSPS Maximum for monthly Maximum for any 1 day average Pollutant or pollutant property Chromium Lead Nickel Zinc Aluminum Iron Oil …

NR 262.14 Pretreatment standards for existing sources. (1) Except as provided in 40 CFR 403.7 and 403.13, any existing source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall comply with 40 CFR Part 403 and achieve the following …

NR 262.15 Pretreatment standards for new sources. Except as provided in 40 CFR 403.7 and 403.13, any new source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall comply with 40 CFR Part 403 and achieve the following pretreatment s…

NR 262.20 Applicability; description of the cast iron basis material subcategory. This subcategory applies to discharges to waters of the state and introductions of pollutants into publicly owned treatment works from porcelain enameling of cast iron basis materials. History: Cr. …

NR 262.21 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subcategory shall ac…

NR 262.22 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subcategory shall achieve …

NR 262.23 New source performance standards. Any new source subject to this subcategory shall achieve the following new source performance standards: (1) There may not be discharge of process wastewater pollutants from metal preparation operations. (2) The discharge of process was…

NR 262.24 Pretreatment standards for existing sources. (1) Except as provided in 40 CFR 403.7 and 403.13, any existing source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall comply with 40 CFR Part 403 and achieve the following …

NR 262.25 Pretreatment standards for new sources. Except as provided in 40 CFR 403.7, any new source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall comply with 40 CFR Part 403 and achieve the following pretreatment standards fo…

NR 262.30 Applicability; description of the aluminum basis material subcategory. This subcategory applies to discharges to waters of the state and introductions of pollutants into publicly owned treatment works from porcelain enameling of aluminum basis materials. History: Cr. Re…

NR 262.31 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subcategory shall ac…

NR 262.32 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subcategory shall achieve …

NR 262.33 New source performance standards. Any new source subject to this subcategory shall achieve the following new source performance standards: NSPS Maximum for any 1 day Pollutant or pollutant property Chromium Lead Nickel Zinc Aluminum Iron Oil and grease TSS pH Chromium L…

NR 262.34 Pretreatment standards for existing sources. (1) Except as provided in 40 CFR 403.7 and 403.13, any existing source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall comply with 40 CFR Part 403 and achieve the following …

NR 262.35 Pretreatment standards for new sources. Except as provided in 40 CFR 403.7, any new source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall comply with 40 CFR Part 403 and achieve the following pretreatment standards fo…

NR 262.40 Applicability; description of the copper basis material subcategory. This subcategory applies to discharges to waters of the state and introductions of pollutants into publicly owned treatment works from porcelain enameling of copper basis materials. History: Cr. Regist…

NR 262.43 New source performance standards. Any new source subject to this subcategory shall achieve the following new source performance standards: NSPS Maximum for monthly Maximum for any 1 day average Pollutant or pollutant property Chromium Lead Nickel Zinc Aluminum Iron Oil …

NR 262.45 Pretreatment standards for new sources. Any new source subject to this subcategory which introduces pollutants into a publicly owned treatment works shall Metal Coating Metal Coating preparation operation preparation operation 2 Metric units-mg/m of area processed or co…

NR 262.50 Cross-references. The federal citations in this chapter correspond to provisions of the Wisconsin Administrative Code and Wisconsin Statutes. The federal citations may be cross-referenced in the following table: CODE OF FEDERAL REGULATIONS CORRESPONDING STATE CODE SECTI…

NR 263.01 Purpose. The purpose of this chapter is to establish effluent limitations, standards of performance and pretreatment standards for discharges of process wastes from the coil coating category of point sources and its subcategories. History: Cr. Register, April, 1989, No.…

NR 263.015 Applicability. This chapter applies to any coil coating facility or to any canmaking facility that discharges or may discharge pollutants to waters of the state or into a publicly owned treatment works. History: Cr. Register, April, 1989, No. 400, eff. 5-1-89.

NR 263.02 General definitions. The following definitions are applicable to terms used in this chapter. Definitions of other terms and the meanings of other abbreviations are set forth in ss. NR 205.03, 205.04 and 211.03. (1) XAluminum basis materialY means aluminum, aluminum allo…

NR 263.03 Monitoring and reporting requirements. The following special monitoring and reporting requirements apply to all facilities regulated by this chapter: (1) CYANIDE. Periodic analyses for cyanide are not required when both of the following conditions are met: (a) The first…

NR 263.04 Compliance dates. (1) Any existing source subject to this chapter which discharges to waters of the state shall achieve: (a) The effluent limitations representing BPT by July 1, 1977; and (b) The effluent limitations representing BAT by July 1, 1984. (2) Any new source …

NR 263.10 Applicability; description of the steel basis material subcategory. This chapter applies to discharges to waters of the state and introductions of pollutants into publicly owned treatment works from coil coating of steel basis material coils. History: Cr. Register, Apri…

NR 263.11 Effluent limitations representing the degree of effluent reduction attainable by the application of the best practicable control technology currently available. Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subchapter shall ach…

NR 263.12 Effluent limitations representing the degree of effluent reduction attainable by the application of the best available technology economically achievable. Except as provided in 40 CFR 125.30 to 125.32, any existing point source subject to this subchapter shall achieve t…

NR 263.13 New source performance standards. Any new source subject to this subchapter shall achieve the following NSPS: STEEL BASIS MATERIAL SUBCATEGORY NSPS Maximum for any 1 Maximum for day monthly average Pollutant or mg/m2 (pounds per 1 million ft2) of pollutant property area…

NR 263.14 Pretreatment standards for existing sources. Except as provided in ss. NR 211.13 and 211.14, any existing source subject to this subchapter which introduces pollutants into a publicly owned treatment works shall comply with ch. NR 211 and may not exceed the following pr…

NR 263.15 Pretreatment standards for new sources. Except as provided in s. NR 211.13, any new source subject to this subchapter which introduces pollutants into a publicly owned treatment works shall comply with ch. NR 211 and may not exceed the following pretreatment standards f…